Graco 16N654, 16H960, 16N655, 16N927 Install trigger lock over trigger with o-ring facing out

Page 38

Installation

1.Insert wires and tighten screws to connect wires into slots 1 and 2 of trigger switch.

ti19648a

2.Install trigger over top of wires. Route trigger wires behind trigger.

ti19631a

Repair

3. Install trigger lock over trigger with o-ring facing out.

ti19632a

4.Install bolts (42) into motor housing and install screws (43) to connect the clamshell halves. Make sure LED lights and static wick are properly in place. Tighten all four bolts (42) to 50 in-lb (5.6 N•m) and screws (43) to 9 in-lb (1 N•m).

43

42

ti19635a

5.Install pump module into drive module. See Pump Module/Drive Module, page 31.

38

3A2308C

Image 38

Contents Protective Coating Hand-Held Paint Sprayer 3A2308C ModelTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Component Identification DescriptionOperation Charging the BatteryCharger Status Indicator Lights Sprayer Status Indicator Trigger Unlocked red ring is visible Common ProceduresTrigger Locked Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a See Grounding Instructions, SetupStarting a New Job Install/Service Filter if needed Perform Pressure Relief Procedure,Install Tip/Guard Assembly if not installed Filling and Installing CupSetting Pressure Priming PumpTi19655a Ti19656a Ti19654a Ti19653a Aiming Sprayer Getting Started with Basic TechniquesTriggering Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerRemove cup and properly dispose contaminated fluid Cleaning Sprayer Exterior StorageParts Parts List Part Description QtyRemoved. See Install/Service Filter TroubleshootingInstall/Service Filter, Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Repair Inlet ValveOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Metric Technical DataFCC Declaration for Battery Charger 3A2308C 3A2308C Graco Standard Warranty Graco Information