Graco 16H960, 16N655, 16N927, 16N654, 16N656 Charger Electric SHOCK, Fire and Explosion Hazard

Page 5

Warnings

WARNING

CHARGER ELECTRIC SHOCK, FIRE AND EXPLOSION HAZARD

Improper setup or usage can cause electric shock, fire, and explosion.

Charge only in a well-ventilated area and away from flammable or combustible materials, including paints and solvents.

Do not charge on a combustible or flammable surface.

Do not leave battery unattended while charging.

• Immediately unplug charger and remove battery when charging is complete.

• Charge only Graco batteries listed in this manual; other batteries may burst.

Use only in dry locations. Do not expose to water or rain.

• Do not use a charger that is cracked or damaged.

• If the supply cord is damaged, replace the charger or cord, depending on model.

Never force the battery into the charger.

When operating a charger outdoors, always provide a dry location and use an extension cord suitable for outdoor use.

Disconnect the charger from the outlet before cleaning.

Ensure that the outside surface of the battery is clean and dry before plugging into the charger.

Do not attempt to charge non-rechargeable batteries.

Do not disassemble the charger. Take charger to authorized service center when service or repair is required.

PRESSURIZED ALUMINUM PARTS HAZARD

Use of fluids that are incompatible with aluminum in pressurized equipment can cause serious chemical reac- tion and equipment rupture. Failure to follow this warning can result in death, serious injury, or property dam- age.

Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents.

Many other fluids may contain chemicals that can react with aluminum. Contact your material supplier for compatibility.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swal- lowed.

Read MSDS’s to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

PERSONAL PROTECTIVE EQUIPMENT

Wear appropriate protective equipment when in the work area to help prevent serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This protective equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

3A2308C

5

Image 5
Contents Model Protective Coating Hand-Held Paint Sprayer 3A2308CTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Description Component IdentificationOperation Charging the BatteryCharger Status Indicator Lights Sprayer Status Indicator Trigger Unlocked red ring is visible Common ProceduresTrigger Locked Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a See Grounding Instructions, SetupStarting a New Job Perform Pressure Relief Procedure, Install/Service Filter if neededFilling and Installing Cup Install Tip/Guard Assembly if not installedPriming Pump Setting PressureTi19655a Ti19656a Ti19654a Ti19653a Triggering Sprayer Getting Started with Basic TechniquesAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningRemove cup and properly dispose contaminated fluid Storage Cleaning Sprayer ExteriorParts Part Description Qty Parts ListInstall/Service Filter, TroubleshootingRemoved. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Inlet Valve RepairOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Metric Technical DataFCC Declaration for Battery Charger 3A2308C 3A2308C Graco Information Graco Standard Warranty