Graco 16N655, 16H960, 16N927, 16N654, 16N656 important safety instructions Ti19632a Ti19641a

Page 36

3.Set motor housing into right half of clamshell and loosely install two bolts (42) to motor housing as shown below.

42

Repair

7.Install ground terminal to stud and tighten second nut onto stud. Install wire up along handle.

ti19629a

4. Route wires from motor down the handle.

ti19630a

5.Assemble trigger over top of wires. Route trigger wires behind trigger.

ti19631a

6. Insert trigger lock over trigger with o-ring facing out.

ti19632a

ti19641a

8.Insert static wick into right half of clamshell and install left clamshell to right clamshell.

ti19634a

NOTICE

Wires can become damaged when pinched between clamshell halves. Make sure no wires are pinched during reassembly.

9.Install two bolts (42) to motor housing and install screws (43) to connect clamshell halves. Make sure LED lights and static wick are securely in place. Tighten bolts (42) to 50 in-lb (5.6 N•m) and screws (43) to 9 in-lb (1 N•m).

43

42

ti19635a

10.Install pump module into drive module. See Pump Module/Drive Module, page 31.

36

3A2308C

Image 36
Contents Protective Coating Hand-Held Paint Sprayer 3A2308C ModelTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Component Identification DescriptionCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Install/Service Filter if needed Perform Pressure Relief Procedure,Install Tip/Guard Assembly if not installed Filling and Installing CupSetting Pressure Priming PumpTi19655a Ti19656a Ti19654a Ti19653a Getting Started with Basic Techniques Triggering SprayerAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerRemove cup and properly dispose contaminated fluid Cleaning Sprayer Exterior StorageParts Parts List Part Description QtyTroubleshooting Install/Service Filter,Removed. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Repair Inlet ValveOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Standard Warranty Graco Information