Graco 16H960, 16N655, 16N927, 16N654, 16N656 important safety instructions Ti19857a Ti19860a

Page 40

2.If unit has accessible retaining bolt shown below, proceed to step 3. If unit does not have accessible retaining bolt, proceed to step 5.

Repair

5.Install new gear into drive housing. Pull the clam- shell up and screw in retaining bolt to retain gear. Torque to 30 in-lb (3.4 N•m).

ti19858a

3.Install new gear into drive housing. Screw retaining bolt into drive housing to retain gear. Torque to 30 in-lb (3.4 N•m).

ti19857a

ti19860a

4.Install pump module to drive module. See Pump Module/Drive Module, page 31.

ti19624a

ti19860a

ti19879a

6.Install two bolts connecting drive to clamshell. Torque to 50 in-lb (5.6 N•m). Install four screws connecting clamshell halves. Torque to 9 in-lb (1.0 N•m).

ti19862a	ti19880a

7.Install pump module to drive module. See Pump Module/Drive Module, page 31.

40

3A2308C

Image 40

Contents Protective Coating Hand-Held Paint Sprayer 3A2308C ModelTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Component Identification DescriptionCharger Status Indicator Lights Charging the BatteryOperation Sprayer Status Indicator Trigger Locked Common ProceduresTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Starting a New Job SetupSee Grounding Instructions, Install/Service Filter if needed Perform Pressure Relief Procedure,Install Tip/Guard Assembly if not installed Filling and Installing CupSetting Pressure Priming PumpTi19655a Ti19656a Ti19654a Ti19653a Getting Started with Basic Techniques Triggering SprayerAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerRemove cup and properly dispose contaminated fluid Cleaning Sprayer Exterior StorageParts Parts List Part Description QtyTroubleshooting Install/Service Filter,Removed. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Repair Inlet ValveOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a FCC Declaration for Battery Charger Technical DataMetric 3A2308C 3A2308C Graco Standard Warranty Graco Information