Graco 16N654, 16H960, 16N655, 16N927, 16N656 important safety instructions Clamshell

Page 33

Repair

Clamshell

Removal

1.Engage trigger lock and put prime/pressure relief valve in UP position to relieve pressure.

ti19347a ti19350a

2. Remove material cup and battery.

6.Remove nut from ground stud. Remove ring termi- nal and unscrew second nut from ground stud. Remove ground stud from clamshell.

ti19638a

7.Carefully remove motor, motor housing, switch, con- trol board, indicator lights, trigger lock, and static wick from clamshell.

ti19360a

ti19617a

ti19639a

3.Remove pump module from drive module. See Pump Module/Drive Module, page 31.

4.Remove screws (42) from motor housing.

42

ti19636a

5.Remove screws (43) from clamshell.

43

ti19637a

Installation

1. Insert control board into right half of clamshell.

ti19627a

2.Install two LED lights into designated slot in right half of clamshell. Push wire bundle into slots in clamshell.

ti19628a

3A2308C

33

Image 33

Contents Model Protective Coating Hand-Held Paint Sprayer 3A2308CTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Description Component IdentificationCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Perform Pressure Relief Procedure, Install/Service Filter if neededFilling and Installing Cup Install Tip/Guard Assembly if not installedPriming Pump Setting PressureTi19655a Ti19656a Ti19654a Ti19653a Triggering Sprayer Getting Started with Basic TechniquesAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningRemove cup and properly dispose contaminated fluid Storage Cleaning Sprayer ExteriorParts Part Description Qty Parts ListInstall/Service Filter, TroubleshootingRemoved. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Inlet Valve RepairOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Information Graco Standard Warranty