Graco 16N927, 16H960, 16N655, 16N654, 16N656 Setup, Starting a New Job, See Grounding Instructions

Page 12

Setup

Flammable fumes (such as solvent and paint fumes) in work area can ignite or explode.

See Grounding Instructions, page 3.

Do not spray flammable or combustible liquids in a con- fined area.

Keep spray area well-ventilated. Keep a good supply of fresh air moving through the area.

Operation

3. Thread lid onto cup and connect cup to sprayer.

ti19354ati19384a

4. Put prime/pressure relief valve in UP position.

NOTICE

Your sprayer is NOT compatible with harsh cleaners such as chlorine bleach. Using these cleaners will cause damage to the sprayer.

Starting a New Job

NOTICE

Always flush any cleaning material from the previous use before starting a new job. If the new spraying material is not compatible with leftover material in the pump, adverse reactions could ruin new material.

NOTICE

Do NOT spray zinc coatings or materials with aggregate. Accelerated pump wear will occur.

1. Engage trigger lock.

ti19350a

2.Install liner into cup and fill liner 1/2 full with appro- priate cleaning fluid for material about to be sprayed.

ti19348a

ti19347a

NOTE: After storage, the piston seals need to be energized prior to next use to prevent leakage. To energize, follow steps below:

a.Prime system with flushing fluid.

b.Spray at low pressure setting “1” for 10 sec- onds.

c.Drain fluid. You are now ready to spray.

5.You MUST set pressure control to setting “1”.

6.Disengage trigger lock, turn sprayer upside-down and trigger for approximately 5 seconds to recircu- late material.

ti19374a

12

3A2308C

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Protective Coating Hand-Held Paint Sprayer 3A2308C ModelTable of Contents Grounding Instructions Skin Injection Hazard Charger Electric SHOCK, Fire and Explosion Hazard Component Identification DescriptionCharging the Battery Charger Status Indicator LightsOperation Sprayer Status Indicator Common Procedures Trigger LockedTrigger Unlocked red ring is visible Adjusting Pressure Ti19655a Ti19656a Ti19654a Ti19653a Setup Starting a New JobSee Grounding Instructions, Install/Service Filter if needed Perform Pressure Relief Procedure,Install Tip/Guard Assembly if not installed Filling and Installing CupSetting Pressure Priming PumpTi19655a Ti19656a Ti19654a Ti19653a Getting Started with Basic Techniques Triggering SprayerAiming Sprayer Pulsating MaterialUnclogging Spray Tip/Guard Assembly Shutdown and Cleaning Flushing SprayerRemove cup and properly dispose contaminated fluid Cleaning Sprayer Exterior StorageParts Parts List Part Description QtyTroubleshooting Install/Service Filter,Removed. See Install/Service Filter Job or Refilling the Cup,See Charging the Battery, Spray Pattern Diagnostics See Shutdown and Cleaning, Repair Inlet ValveOutlet Valve Pressure Control Knob Pump Module/Drive Module Pump Rebuild Kit Clamshell Route wires from motor down the handle Motor/Control Board Replacement Kit Ti19632a Ti19641a Switch Assembly Install trigger lock over trigger with o-ring facing out Gear Replacement Ti19857a Ti19860a Technical Data FCC Declaration for Battery ChargerMetric 3A2308C 3A2308C Graco Standard Warranty Graco Information
Top Page Image Contents