Campbell Hausfeld EZ5000 Series Using Your, Cleaning, Storage, Coatings That Clean Up With Water

Operating Instructions & Parts Manual

Step 2 – Using Your	Use whatever material the paint man-
	ufacturer recommends for cleaning.
HousePainter (Cont.)
	For overnight storage, submerge the
roller with paint. When paint begins
	gun in a bucket of the appropriate
to dot the roller cover (see Figure 19)	cleaning fluid (see Figure 20). Leave
continue to hold the trigger and begin	the suction and bypass tubes in the
rolling the wall . When the roller cover	bucket of coating. Cover the tubes and
is saturated, release the trigger and	bucket with a damp towel, or if using
continue rolling the surface. Only	latex paint, pour a very thin layer of
depress the trigger when the roller	water over top of paint. Stir water into
cover needs more paint.	paint the next morning.
The paint saved with this system is	Coatings That Clean Up With Water.
approximately 1/3 of the amount a	When you are finished painting, turn
manual roller uses. You also save time
	the One Touch Control knob to the
and energy by eliminating the bend-
	prime position (see Figure 14). Lift the
ing required when using a roller pan.
	suction tube above the paint level and
Refer to the roller instructions for	allow any residual coating to flow into
cleaning procedures.	the coating container from the bypass
Step 3 – Cleaning &	tube. When there is little to no paint
	coming out of the bypass tube, turn
Storage
	the sprayer off.
Cleaning the HousePainter is very sim-	Place the suction tube in a bucket of
ple. It is basically just following the	warm water. If you use a waste bucket,
same procedure with water or solvent	place the bypass tube in it. If not, the
that you have just done with the coat-	bypass tube should also go into the
ing. To speed the process, place the	bucket of warm
bypass tube in a waste bucket so you	water. Turn the One
do not contaminate the cleaning fluid.	Touch Control to
	the clean pump
	position (see Figure
	21).
	If using a waste	Figure 21 - Icon
		showing Clean
	bucket, allow the
		Pump position
	sprayer to run in this
	mode until water is no longer coming
	out of the bypass tube. If a waste
	bucket is not being used, allow the
	water to circulate for about 5 minutes.
	Repeat this process at least once, or
	until you see clear water coming out
Figure 20– Submerge gun in bucket
	of the bypass tube. Make sure to turn
of appropriate cleaning fluid	the HousePainter off when

www.chpower.com

10