EZ5000 Series
General Safety (Cont.)
◗turn the unit to the Prime position (see Figure 5) ...OR ...
◗turn the unit to the Off posi- tion (see Figure 6).
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Figure 5 - Icon |
| Figure 6 - Icon | |
| showing Prime |
| showing Off | |
| position |
| position | |
|
|
|
|
|
Be thoroughly familiar with the controls.
To reduce the risk
! WARNING of injury:
• Always wear appropriate gloves, eye protection, and a respirator or mask when painting.
• Do not operate or spray near children. Keep children away from equipment at all times.
• Do not overreach or stand on an unstable support. Keep effective footing and balance at all times.
• Stay alert and watch what you are doing.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not kink or
• Do not expose the hose to tem- peratures or to pressures in excess of those specified by the manu- facturer.
• Do not use the hose to pull or lift the equipment.
Set-Up
TOOLS REQUIRED
◆Screwdriver
◆Two adjustable wrenches – or two 3/4”
◆Extension cord – see Table 1 on Page 2.
Remove all components from the box. Remove the cap from the hose adapter and attach one end of the high pressure hose to the sprayer (see Figure 7). Attach the other end of the hose to the gun.
Figure 7 – Attach hose to sprayer
PREPARATION
Each sprayer is tested at the factory. Residual amounts of test fluid will remain in the pump. If you are using an
5www.chpower.com