Ryobi CD100 manuel dutilisation Wood DRILLING, Metal DRILLING

Page 10

OPERATION

WOOD DRILLING

For maximum performance, use high speed steel bits for wood drilling.

Begin drilling at a very low speed to prevent the bit from slipping off the starting point. Increase the speed as the drill bit bites into the material.

When drilling through holes, place a block of wood behind the workpiece to prevent ragged or splintered edges on the back side of the hole.

METAL DRILLING

For maximum performance, use high speed steel bits for metal or steel drilling.

Begin drilling at a very low speed to prevent the bit from slipping off the starting point.

Maintain a speed and pressure which allows cutting without overheating the bit. Applying too much pressure will:

Overheat the drill;

Wear the bearings;

Bend or burn bits; and

Produce off-center or irregular-shaped holes.

When drilling large holes in metal, start with a small bit, then finish with a larger bit. Also, lubricate the bit with oil to improve drilling action and increase bit life.

10 — English

Image 10
Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionElectrical Safety General Safety RulesPersonal Safety Power Tool USE and CareBattery Tool USE and Care ServiceSpecific Safety Rules Symbol Signal Meaning SymbolsName DESIGNATION/EXPLANATION Features AssemblyOperation Drilling Installing BitsRemoving Bits See Figures 6 7,Wood DRILLING Metal DRILLINGBattery Pack Preparation for Recycling MaintenanceGeneral Maintenance To Retighten a Loose ChuckEnglish Garantie Table DES MatièresRègles DE Sécurité Générales AvertissementUtilisation ET Entretien DE LA Batterie DépannageRègles DE Sécurité Particulières Symbole NOM Désignation / Explication SymbolesSymbole Signal Signification AVERTISSEMENT Caractéristiques AssemblageRetrait DU Bloc DE Batteries Installation DU Bloc DE BatteriesUtilisation Caractéristiques Relatives À LA Protection DES PilesPerçage Installation DES EmboutsRetrait DES Embouts AvertissementPerçage DU Bois Perçage DU MétalRetrait DU Mandrin EntretienEntretien Général Serrage D’UN Mandrin DesserréIntroducción Índice DE ContenidoGarantía Seguridad Personal Reglas de seguridad generalesAdvertencia Seguridad EléctricaEmpleo Y Cuidado DE LA Herramienta DE BateríaS ServicioReglas de seguridad específicas Precaución SímbolosPeligro Símbolo Señal SignificadoCaracterísticas ArmadoFuncionamiento Remoción DE LAS Brocas Bandeja MAG TrayInstalación DE LAS Brocas TaladradoTaladrado EN Madera Taladrado EN MetalDesmontaje DEL Portabrocas MantenimientoMantenimiento General Para Apretar EL Portabrocas Cuando SE AflojeEnglish Switch trigger gâchette, gatillo del interruptor Db a Right / Correct / Forma Correcta OPERATOR’S Manual / 12 volt drill-driver ONE World TECHNOLOGIES, INC