Grizzly G0656X Machine Inventory See, Wood Crate Figure Qty, Assembly Fasteners Qty, Clean Up See

MODEL G0656

8" JOINTER w/BUILT-IN

MOBILE BASE

MANUAL UPDATE

This update covers changes made to the machine after the owner's manual was printed. All page num- ber references refer to the owner's manual for this machine. Keep this update with your owner's man- ual for future reference. If you have questions, contact Tech Support at (570) 546-9663 or by email at techsupport@grizzly.com.

Machine Inventory (See Page 11)

The fence assembly and fence bracket are no longer pre-installed on the jointer assembly by the factory for shipping, as shown in Figure 3 on G0656 Manual Page 11. These items have been added to the machine inventory (Figure 1). Refer to the owner's manual for the rest of the inven- tory.

Wood Crate (Figure 1):		Qty
A.	Fence Bracket	1
B.	Fence Assembly	1
	A
		B

Figure 1. New inventory items.

The items below have been added to the original list of included assembly fasteners:

Assembly Fasteners		Qty
• Cap Screws M8-1.25 x 35 (Fence)		............ 4
• Lock Washers 8mm (Fence)		4
•	Flat Washers 8mm (Fence)	4
•	Key 4 x 4 x 12 (Right Handwheel)	1

Clean Up (See Page 13)

The following sliding surfaces must be cleaned:

•Fence carriage

•Fence bracket

Assembly (See Page 14)

Assembly of the fence bracket, fence carriage assembly, and handwheels has changed. Steps 2-5below replace Steps 15-17on Page 15 of the G0656 Owner's Manual.

1.Follow Steps 1-14 on Pages 14 & 15.

2.Align the mounting holes on the fence bracket and jointer, and fasten with the M8-1.25 x 35 cap screws, flat washers and lock washers, as shown in Figure 2. Do not fully tighten the fasteners yet.

Fence

Bracket

Figure 2. Fence bracket installed.

COPYRIGHT © FEBRUARY, 2008 BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#BL10444 PRINTED IN CHINA