Grizzly G0656X manual Handwheels installed, Perform Steps 18-26 on Pages 15

Page 14

3.Remove the locking nut and flat washer (Figure 3) from the fence lock handle bolt (Figure 4), place the fence assembly over the jointer tables and fence bracket, and insert the bolt through the fence bracket slot, making sure the carriage fits over the key (Figure 3).

Key

Carriage

Flat Washer

Locking Nut

Figure 3. Fence locking nut and washer

removed.

4.Secure the fence lock handle bolt with the locking nut and flat washer removed in Step 3, as shown in Figure 4, and final tighten the fence bracket.

Flat Washer

Locking Nut

Fence Lock

Handle Bolt

Figure 4. Fence installed.

5.Install the round-slotted handwheel onto the right shaft with the 4 x 4 x 12 key, and install the square-slotted handwheel onto the left shaft, using the cap screws and flat washers already mounted on the handwheel shafts.

	Square Slotted	Round Slotted
	Handwheel
		Handwheel

Figure 5. Handwheels installed.

6.Perform Steps 18-26 on Pages 15 & 16.

Image 14

Contents To set the outfeed table height Machine Inventory Setting Outfeed Table HeightWood Crate Qty Replacing Carbide Inserts Tools Needed QtyTo rotate or change a carbide insert Machine Data Sheet Cutting Capacities Table Parts Breakdown Table Parts List DescriptionFence Parts Breakdown Fence Parts List Stand Parts Breakdown Stand Parts List Label Placement Assembly See Follow Steps 1-14 on Pages 14 Assembly Fasteners QtyClean Up See Machine Inventory SeeHandwheels installed Perform Steps 18-26 on Pages 15Model G0656 Page Table of Contents Foreword Contact InfoMachine Data Sheet G0656 8 Jointer with Built-In Mobile Base Identification Safety Instructions for Machinery G0656 8 Jointer with Built-In Mobile Base Additional Safety Instructions for Jointers Full Load Amperage Draw Power Connection Device220V Operation Minimum Circuit RequirementsUnpacking Setup SafetyItems Needed for Setup Description QtyInventory Cardboard Box Figure QtyHardware Recognition Chart Site Considerations Clean UpPlacement Location Floor LoadAssembly To assemble the jointerChecking belt alignment Cutterhead Pulley Motor Page Dust Collection Setting Outfeed To connect a dust collection hoseTest Run Recommended AdjustmentsFactory adjustments that should be verified Tighten V-BeltOperation Safety Jointer Overview OperationsBasic Controls Start Button Starts motorStock Inspection Requirements Scrape all glue off of boards before joint- ingSquaring Stock Surface PlaningEdge Jointing To surface plane on the jointerBevel Cutting To edge joint on the jointerRabbet Cutting To bevel cut on the jointerTo rabbet cut on the jointer H7765-8 Byrd Shelix Cutterhead G3631-Jointer Knife HoneDispoz-A-BladeHolder and Knife T20448T20452 T20501 T20456 H0736 Our most popular eye protectionDaily Check ScheduleLubrication Monthly CheckBelts CleaningTo adjust/replace the V-belt Troubleshooting Motor & ElectricalCutting To inspect the knives Setting/Replacing KnivesInspecting Knives To set or replace the knivesPage Positive Stop Bolts Setting Infeed TableCalibrating Depth Scale Depth Stop LeverTo set the 90˚ fence stop Setting Fence StopsTo set the 45˚ inward fence stop To set the 45˚ outward fence stop Adjusting GibsTo adjust the table gibs Wiring Diagram See FigureTable Parts Breakdown GIB Bolt Fence Parts Breakdown Fence Parts List Stand Parts Breakdown Description PAINT1 Grizzly Green TOUCH-UP Paint Page Page Warranty and Returns