Grizzly G0656X manual To rotate or change a carbide insert

Page 3

To rotate or change a carbide insert:

1.Disconnect JOINTER from power!

2.Move the cutterhead guard out of the way, or remove it.

3.Remove any sawdust from the head of the carbide insert Torx screw.

4.Remove the Torx screw and carbide insert.

5.Clean all dust and dirt off of the insert and the cutterhead pocket from which the insert was removed, and replace the insert so a fresh, sharp edge is facing outward. Make sure the insert is seated in the pocket on the cutterhead.

G0656X Manual Insert

Note: Proper cleaning is critical to achieving a smooth finish. Dirt or dust trapped between the insert and cutterhead will slightly raise the insert, and make noticeable marks on your workpieces the next time you cut.

6.Lubricate the Torx screw threads with a light machine oil, wipe the excess oil off the threads, and torque the Torx screw to 48-50 inch/pounds.

Note: Excess oil may squeeze between the insert and cutterhead or at the bottom of the screw hole, causing hydrostatic lock and preventing the screw from fully tightening, thereby lifting the insert or screw slightly and affecting workpiece finishes. Make sure to carefully clean off any excess oil to prevent this from happening.

-3-

Image 3

Contents Machine Inventory Setting Outfeed Table Height Wood Crate QtyTo set the outfeed table height Tools Needed Qty Replacing Carbide InsertsTo rotate or change a carbide insert Machine Data Sheet Cutting Capacities Table Parts Breakdown Description Table Parts ListFence Parts Breakdown Fence Parts List Stand Parts Breakdown Stand Parts List Label Placement Machine Inventory See Assembly Fasteners QtyClean Up See Assembly See Follow Steps 1-14 on Pages 14Perform Steps 18-26 on Pages 15 Handwheels installedModel G0656 Page Table of Contents Contact Info ForewordMachine Data Sheet G0656 8 Jointer with Built-In Mobile Base Identification Safety Instructions for Machinery G0656 8 Jointer with Built-In Mobile Base Additional Safety Instructions for Jointers Minimum Circuit Requirements Power Connection Device220V Operation Full Load Amperage DrawDescription Qty Setup SafetyItems Needed for Setup UnpackingCardboard Box Figure Qty InventoryHardware Recognition Chart Floor Load Clean UpPlacement Location Site ConsiderationsTo assemble the jointer AssemblyChecking belt alignment Cutterhead Pulley Motor Page To connect a dust collection hose Dust Collection Setting OutfeedTighten V-Belt Recommended AdjustmentsFactory adjustments that should be verified Test RunOperations Operation Safety Jointer OverviewStart Button Starts motor Basic ControlsScrape all glue off of boards before joint- ing Stock Inspection RequirementsSurface Planing Squaring StockTo surface plane on the jointer Edge JointingTo edge joint on the jointer Bevel CuttingTo bevel cut on the jointer Rabbet CuttingTo rabbet cut on the jointer G3631-Jointer Knife Hone H7765-8 Byrd Shelix CutterheadDispoz-A-BladeHolder and Knife Our most popular eye protection T20448T20452 T20501 T20456 H0736Monthly Check ScheduleLubrication Daily CheckCleaning To adjust/replace the V-beltBelts Motor & Electrical TroubleshootingCutting To set or replace the knives Setting/Replacing KnivesInspecting Knives To inspect the knivesPage Depth Stop Lever Setting Infeed TableCalibrating Depth Scale Positive Stop BoltsSetting Fence Stops To set the 45˚ inward fence stopTo set the 90˚ fence stop Adjusting Gibs To adjust the table gibsTo set the 45˚ outward fence stop See Figure Wiring DiagramTable Parts Breakdown GIB Bolt Fence Parts Breakdown Fence Parts List Stand Parts Breakdown Description PAINT1 Grizzly Green TOUCH-UP Paint Page Page Warranty and Returns