Grizzly G0604 Calibrating Depth, Scale, Setting Fence Stops, To calibrate the depth scale

Calibrating Depth
Scale
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Tools Needed	Qty
Straightedge	1
Phillips Screwdriver	1
To calibrate the depth scale:

1.DISCONNECT JOINTER FROM POWER SOURCE!

2.Loosen the infeed table positive stop bolts.

3.Use the straightedge to help adjust the infeed table exactly even with the outfeed table, as shown in Figure 59.

������������ ������� ������

Figure 59. Infeed table even with outfeed table.

4.Using a screwdriver, adjust the scale pointer to zero (Figure 60), then reset the infeed table positive stops.

Setting Fence Stops

The fence stops simplify the task of adjusting the fence to 45˚ inward, 90˚, and 45˚ outward (135˚).

Tools Needed	Qty
45° Square	1
90° Square	1
Sliding Bevel	1
Wrench 10mm	1
Hex Wrench 4mm	1
To set the 45˚ inward fence stop:

1.Tilt the fence approximately 45° inward (Figure 61) onto the positive stop bolt.

Figure 61. Fence adjusted 45˚ inward.

2.Loosen the jam nut on the 45° inward positive stop bolt shown in Figure 62.

45° Inward

Positive Stop

Bolt

Figure 60. Depth scale adjusted to “0” position.

-40-

Figure 62. 45° inward positive stop bolt.

3.Adjust the positive stop bolt until the fence is exactly 45° inward while resting on the bolt (verify the angle with a 45° square).

4.Retighten the jam nut loosened in Step 2. G0604 6" X 56" Jointer