Grizzly G0604 Inventory, Jointer Box Figure Qty, Stand Box Figure Qty, Stand Assembly w/Motor

Inventory

After all the parts have been removed from the two boxes, you should have the following items:

Jointer Box: (Figure 2)		Qty
A.	Jointer Assembly	1
B.	Carriage	1
C.	Fence	1
D.	Extension Table	1
E.	Push Blocks	2
F.	Cutterhead Guard	1

A

B

E

C

D

F

G

G.Tool Hardware Bag

—Hex Wrenches 2.5, 4, 5, 6, 8mm...	1 Each
—Open-end Wrench 8/10mm	1
H. Knife Setting Jig (not shown)	1
Stand Box: (Figure 3)	Qty

Figure 2. Box 1 inventory contents.

I

I.	Stand Assembly w/Motor	........................... 1
J.	Pedestal Switch	1
K.	Dust Port	1
L.	Wheel Assembly	1
M.	Belt Guard	1
N.	V-Belt	1
Assembly Fasteners		Qty

K

J

M

• Hex Bolt M8-1.25 x 50 (Wheel/Stand)		1
• Flat Washer 8mm (Wheel/Stand)		1
• Hex Bolts M10-1.5 x 55 (Wheel/Stand)		2
•	Flat Washers 10mm (Wheel/Stand)	2
•	Hex Nuts M10-1.5 (Wheel/Stand)	2

•Cap Screws M8-1.25 x 25 (Jointer/Stand) . 4

• Lock Washers 8mm (Jointer/Stand)		4
• Flange Bolts M6-1 x 12 (Belt Guard)		2
• Hex Nuts 6mm (Belt Guard)		2
• Flat Washers 6mm (Belt Guard)		2
• Cap Screws M8-1.25 x 30	(Fence)	2
• Cap Screws M8-1.25 x 20	(Pedestal)	2
• Lock Washers 8mm (Pedestal)		2
• Flat Washers 8mm (Pedestal)		2
• Phillips Screws M5-.8 x 16 (Dust Port)		4
• Flat Washers 5mm (Dust Port)		4
• Cap Screws M10-1.5 x 30	(Carriage)	2
• Flat Washers 10mm (Carriage)		2
• Cap Screws M6-1 x 20 (Ext Table)		2

L N

Figure 3. Box 2 inventory contents.

In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expedi- ency, replacements can be obtained at your local hardware store.

NOTICE

Some assembly fasteners may arrive pre- installed on the machine. Check the mount- ing locations on the machine before assum- ing that any items from the inventory list are missing.

G0604 6" X 56" Jointer -11-