Grizzly G0604 owner manual Fence, To install the fence

Page 19

Fence
Components and Hardware Needed:	Qty
Carriage	1
Fence	1
Cap Screws M10-1.5 x 30	2
Flat Washers 10mm	2
Cap Screws M8-1.25 x 30	2
To install the fence:

1.Attach the fence carriage to the back of the table base (see Figure 13), but do not fully tighten the bolts yet.

Figure 13. Fence carriage installed.

2.Place a piece of paper on the table and slide the carriage over the table top to allow it to rest on the paper and self align, as shown in Figure 14, then tighten the carriage mounting bolts.

Note: The paper will keep the carriage from making direct contact with the table, which will keep the fence from dragging across the table when it is installed.

G0604 6" X 56" Jointer

Figure 14. Carriage slide propped up on paper.

3.Attach the fence to the carriage, as shown in Figure 15.

Figure 15. Attaching fence to carriage.

4.Install the tilt lever as shown in Figure 16.

Figure 16. Installing the fence tilt lever.

-17-

Image 19

Contents Model G0604 Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Jointers 110V Operation Circuit RequirementsUnpacking SetupSetup Safety Items Needed for SetupJointer Box Figure Qty Stand Assembly w/MotorAssembly Fasteners Qty InventoryHardware Recognition Chart Components and Hardware Needed Qty CleanupWheel Assembly Site ConsiderationsJointerV-Belt To install the V-beltTo mount the jointer to the stand To check the outfeed table height Checking Outfeed Table HeightSetting Outfeed Table Height on To install the extension tableExtension Table Fence To install the fenceCutterhead Guard Pedestal SwitchTo install the cutterhead guard To install the pedestal switchDust Port Knife Setting JigTest Run Recommended Factory adjustments that should be verifiedOperations Operation Safety Basic ControlsStart & Stop Buttons Figure Tilt lock and plunger locations Stock Inspection and RequirementsSquaring Stock Minimum dimensions for edge JointingTo surface plane on the jointer Surface PlaningTo edge joint on the jointer Edge JointingTo bevel cut on the jointer Bevel CuttingH9218-6 Byrd Shelix Cutterhead AccessoriesG3631-Jointer/Planer Knife Hone Dispoz-A-BladeHolder and Knife H1300 H1298 G7984 H2347 H0736 Our most popular safety glassesLubrication MaintenanceBelt Cleaning ScheduleTroubleshooting Guide ServiceCutting Inspecting Knives Adjusting/Replacing KnivesTo inspect the knives Tools Needed Qty To adjust/replace the knivesPage To check the outfeed table parallelism Checking/Adjusting Table ParallelismTo check the infeed table parallelism To adjust the table parallelismTo set the outfeed table height Setting Outfeed Table HeightPositive stop bolts for infeed table Setting Infeed TableTo calibrate the depth scale Setting Fence StopsCalibrating Depth ScaleTo set the 45 outward fence stop To set the 90˚ fence stopWiring Diagram Electrical Components Jointer Parts Breakdown Description Jointer Parts ListBumper Stand/Motor Parts Breakdown Stand/Motor Parts List PLABEL-29 Cutterhead Guard Label Warranty and Returns G0604 6 X 56 Jointer Comments Warranty CardBOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog