Miller Electric Millermatic DVI manual Connecting To Weld Output Terminals, Installing Work Clamp

4-5. Connecting To Weld Output Terminals

4

1

	2
Tools Needed:	3
3/4 in (19 mm)

Do not place

anything between weld cable terminal and copper bar.

803 778-A

	Correct Installation
Y Turn off power before connecting to	1	Weld Output Terminal
weld output terminals.	2	Supplied Weld Output Terminal Nut
Y Failure to properly connect weld	3	Weld Cable Terminal
cables may cause excessive heat	4	Copper Bar
and start a fire, or damage your ma-
	Remove supplied nut from weld output ter-
chine.

Incorrect Installation

minal. Slide weld cable terminal onto weld output terminal and secure with nut so that weld cable terminal is tight against copper bar. Do not place anything between weld

cable terminal and copper bar. Make sure that the surfaces of the weld cable terminal and copper bar are clean.

4-6. Installing Work Clamp

1 Work Cable

2 Boot

Route cable through front panel opening. Slide boot onto work cable.

3 Negative (−) Output Terminal

Connect cable to terminal and cover connection with boot.

Close door.

2 1

3

Tools Needed:

3/4 in 803 859-B

OM-1330 Page 12