FIG. 1 | CHISEL BIT ADJUSTMENT MODE |
HAMMERDRILLING | CHIPPING |
MODE | MODE |
CHISEL BIT ADJUSTMENT MODE
E
F I
D
A
J B
G
H
E
C
D25602
INTENDED USE
These
This
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and removing accessories, before adjusting or changing
Side Handle (Fig. 1)
WARNING: To reduce the risk of personal injury, ALWAYS operate the tool with the side handle properly installed and securely tightened. Failure to do so may result in the side handle slipping during tool operation and subsequent loss of control. Hold tool with both hands to maximize control.
The side handle clamps to the front barrel (collar) and may be rotated 360° to permit right or
TO MOUNT IN FRONT POSITION (FIG. 2)
1.Unscrew the side handle (C) and disassemble the side handle clamp (J).
2.Snap the steel ring (K) over the collar (L) behind the tool holder
(M). Squeeze both ends of the steel ring together. Mount the bushing (N) and insert the pin (O).
3.Slide the side handle clamp (J) over the bushing and screw on the clamp knob (H)
4.Screw the side handle (C) into the clamp knob (H) and tighten.
English
5