English
6. Using depth gauge (Fig. 16)
(1)Loosen the knob on the side handle, and insert the depth gauge into the mounting hole on the side handle.
(2)Adjust the depth gauge position according to the depth of the hole and tighten the knob bolt se- curely.
7. How to use the drill bit (taper shank) and the
taper shank adaptor. | Side handle |
|
Mounting hole
Depth gauge
(1)Mount the taper shank adaptor to the rotary ham- mer. (Fig. 17)
(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 17)
(3)Turn the switch ON, and drill a hole in prescribed depth.
(4)To remove the drill bit (taper shank), insert the cot- Drill bit ter into the slot of the taper shank adaptor and strike the head of the cotter with a hammer sup- porting on the rests. (Fig. 18)
Fig. 16
Front cap
Taper shank
adapter Grip
Fig. 17
Taper shank
Cotter adaptor
Rests
Fig. 18
19