90558476 VEC157BD.qxp:VEC157BD_ManualEN_072007 11/25/09 1:33 PM Page 5
Using the Built-In Carry Lanyard
The Carry Lanyard may be used to store or carry the Spotlight. Adjust the slide on the cords to keep the Lanyard secure around the supporting object.
CARE AND MAINTENANCE
All batteries lose charge with time, especially when they are warm. Recharge the unit every two months when not in frequent use, preferably using the 120 volt AC method.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent.
The quartz halogen bulb is the only
Spotlight Bulb Replacement
To replace the bulb, you will need a small Phillips screwdriver and a 12 volt, H3 75 watt replacement bulb. During installation, avoid touching the glass part of the bulb. Bulb life may be shortened by installing a bulb with dirt or fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol.
QUARTZ HALOGEN BULB
RUBBER
END CAP
| REFLECTOR | TRIGGER | |
| SWITCH | ||
RETAINING RING | RUBBER | TRIGGER (OFF) | |
“O” RING | |||
LOCK | |||
|
|
RUBBER BEZEL COVER
1.Disconnect the unit from any charging adapters.
2.Push the rubber bezel forward toward the front of the spotlight to reveal two small Phillips screws in the retaining ring.
3.Using the screwdriver, remove (counterclockwise) the two screws. Set them aside.
4.Lift off the retaining ring, glass lens and rubber “O” ring and set them aside.
5.Carefully remove the reflector and bulb assembly.
HAIRPIN RETAINING
WIRES
PHILLIPS
HEAD
SCREWS
BULB
REFLECTOR
6.Disconnect the bulb wire from the red power wire.
7.Unsnap the hairpin retaining wires from the reflector’s flange.
8.Using the screwdriver, loosen the retaining screw to remove the bulb from the reflector (no need to completely remove this screw).
9.Lift out the bulb and detach wire.
10.Insert the replacement bulb into the reflector’s flange.
5