Cisco Systems SMNMADPTR manual Setup the NAM default gateway, Address

Page 30

Configuring the NME-NAM-120S for Management

	Command or Action		Purpose
Step 11 service-module ip default-gateway <NAM-Default-Gateway-Address>			Setup the NAM default gateway
	(or for the NM-NAM)		address.
	analysis-module ip default-gateway <router-side-address>
	Router (config-if)#	service-module ip default-gateway
209.165.201.222
	(or for the NM-NAM)
	Router (config-if)#	analysis-module ip default-gateway
209.165.201.222

Step 12 end

Exit the router configuration mode.

Configuration Example

In this configuration example:

•The external NAM interface is used for management traffic.

•The Integrated-Service-Engine interface is configured as IP unnumbered to borrow the IP address of the loopback interface.

•The borrowed loopback interface IP address is not routable.

•The NAM system is configured with an IP address from the LAN subnet that is connected to the external NAM interface.

•The internal NAM interface is used to monitor WAN traffic on interface Serial 0/0, and the external NAM interface is used to monitor LAN traffic on interface Fast Ethernet 0/0.

•The NME-NAM-120S is installed in router slot 3.

Figure 4 shows the topology used in the example, and the following sections show the router and NAM configurations:

•Router Configuration (Cisco IOS Software), page 32

•NAM Configuration (NAM software), page 32

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

30	OL-14942-02

Image 30

Contents Series multi-services and integrated services routers DescriptionContents Prerequisites for NME-NAM-120SNetwork Modules Router Platform IOS Version Minimum Required?Restrictions for the NME-NAM-120S Upgrade or DowngradeConfiguration File ServerNAM Software Monitoring Traffic Through Internal InterfaceHardware Interfaces Gateway routerFrom the Host-Router CLI How to Install, Upgrade, or Downgrade NME-NAM-120SSetting Up Network Module Interfaces Ip unnumbered type numberCommand or Action Purpose Using the commands ip interface internal and ip addressExample Using the commands ip interface external and ip address ExamplesOpening a Session You can conduct only one session at a timeFrom the Router CLI Control-Shift-6 Closing a SessionUse the following steps to close a session From the Router promptNAM Software Images Upgrading or Reinstalling NAM SoftwareTypes of NAM Software Upgrades PrerequisitesShow config Boot helper Boot compactflash From the Service-Module InterfaceConfigure Upgrading the NME-NAM-120S Application Image Full ImageLocate the following file Session into the NME-NAM-120S consoleOptional Verify your bootloader configuration settings Enter boot helperEnter boot flash Upgrading the NAM Application Image Patch Upgrading the NAM Helper Image NAM CLI FTP server must be reachable from NAM CLI Exit the NAM CLI prompt and get to the NAM loginBecause the exit command closes the session Download and save the NAM helper image to the NAMFrom the Service Module Interface This section describes how to upgrade the NAM helper imageFrom the Router Enable exec Mode Prompt Upgrading the NAM Helper ImageConfigure the bootloader to load Reboot the NAMBreak to the NAM bootloader prompt Address, NAM default gatewayBoot to the NAM application image Configuring the NME-NAM-120S for ManagementReboot the NAM. By default the NAM will Download helper image from FTP serverEnter IOS interface configuration mode Enter IOS exec modeEnter IOS configuration from terminal For the integrated-service-engineSetup a full 32-bit static route for Exit the router configuration modeNAM management address Router Configuration Cisco IOS Software Callout Interface LocationNAM Configuration NAM Software Integrated-service-engine interface Enter the IOS interface configuration modeFor the integrated-service-engine interface Bring up the integrated-service-engineRouter Configuration Cisco IOS Software Configuring the External Interface for Management Enable the loopback interface Enter IOS exec modeEnter IOS configuration from terminal Exit from interface configuration modeSetup the NAM default gateway AddressCallout Interface Location Disabling AAA Login Authentication on the NAM Console Line Login authentication list-name End Show running-configEnters global configuration mode Enables privileged Exec modeEnter your password if prompted Creates a local authentication listIp interface internal external Show ipConfigures the NAM system default gateway address Configures the NAM system IP addressOptional Configures the NAM system broadcast address Optional Enables outside loginsConfiguring the NME-NAM-120S This section provides the following examplesWhat to Do Next Sample Output for the show ip NAM CLI CommandEnabling NAM Packet Monitoring Checking Network Connectivity with PingEnable Configure terminal Ip cef End Show running-configAnalysis-module monitoring Correct interfaces Verify that you enabled the Cisco Express ForwardingSwitching path and enabled packet monitoring on This section provides the following exampleEnabling and Accessing the NAM Traffic Analyzer Ip http server enable or Ip http secure server enableEnter a password Configures a password for the web username Enables the Http serverEnables the Http secure server HTTPs Open a Telnet or SSH session to the NAM. SeeAccessing the NAM Traffic Analyzer Enabling the NAM Traffic AnalyzerChanging the NAM Root Password Password rootChanging the NAM Root Password Resetting the NAM Root Password to the Default ValueTroubleshooting Tips Verifying the NAM Root PasswordOpening and Closing a Telnet or SSH Session to the NAM Enables privileged Exec modeEnter your password if prompted Reloads the software onTelnet Prerequisites SSH PrerequisitesExit Logout Leaves a subcommand mode Return to command modeTo the NAM and return to the Cisco IOS CLI, complete Managing the NME-NAM-120S Shutting Down and Starting Up NME-NAM-120SConfiguration Mode Command Purpose Verifying System Status Configuring Logging Options and Generating Diagnostics Show trace store Additional ReferencesShow trace buffer TraceMIBs MIBs Link MIBsRFCs RFCs TitleFeature Information for Network Analysis Module Technical AssistanceDescription Link Glossary Engine Service module Service engineService or services NetFlowSyslog TelnetVoIP OL-14942-02