Cisco Systems SMNMADPTR manual Examples, Using the commands ip interface external and ip address

How to Install, Upgrade, or Downgrade NME-NAM-120S

	Command or Action	Purpose
Step 6
	service-module external ip address	Specifies the IP address for the external LAN interface on
	external-ip-address subnet-mask	the module. Arguments are as follows:
	Example:	• external-ip-address—IP address for the interface
		• subnet-mask—Subnet mask to append to the IP address
	Router(config-if)# service-module external ip
	address 172.0.0.30 255.255.255.0	This command selects and configures the external interface
		for management traffic. This command is equivalent to
		using the commands ip interface external and ip address
		<address> <mask> on the NME-NAM-120S CLI.
		Note If you want to use the internal interface for
		management traffic, use the Step 5 instead.
Step 7
	service-module ip default-gateway	Specifies the IP address for the default gateway router for
	gateway-ip-address	the module. The argument is as follows:
	Example:	• gateway-ip-address—IP address for the gateway router
		Note Use this step only if you used Step 5 or Step 6.
	Router(config-if)# service-module ip
	default-gateway 10.0.0.40
Step 8
	end	Returns to global configuration mode on the host router.
	Example:
	Router(config-if)# exit
Step 9
	copy running-config startup-config	Saves the router’s new running configuration.
	Example:
	Router# copy running-config startup-config
Step 10
	show running-config	Displays the router’s running configuration, so that you can
		verify address configurations.
	Example:
	Router# show running-config

Examples

The following partial output from the show running-configcommand shows how the interfaces are configured.

interface Integrated-Service-engine1/0 ip address 10.0.0.20 255.255.255.0

service-module ip address 10.0.0.21 255.255.255.0 service-module ip default-gateway 10.0.0.20

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 9