Cisco Systems Expert Guide to Configuring Cisco Network Analysis Module with SM-NM-ADPTR

Configuring the NME-NAM-120S For Network Connectivity

What to Do Next

For information on the NAM Traffic Analyzer, see the User Guide for the Network Analysis Module Traffic Analyzer for your NAM software release. This document is available as online help within the NAM Traffic Analyzer application and on Cisco.com at the following URL:

http://www.cisco.com/en/US/products/sw/cscowork/ps5401/products_user_guide _book09186a00807ed53e.html

Changing the NAM Root Password

This procedure sets a new password to access the root (read/write) level of NAM, where you can enter NAM CLI commands. The factory-set default root password is root.

Prerequisites

Before performing this task, access the NAM console by performing the steps described in the “Closing a Session” section on page 11.

SUMMARY STEPS

1.password root

2.Enter the new password.

3.Enter the new password again.

4.exit

DETAILED STEPS

	Command or Action	Purpose
Step 1
	password root	Starts the process of changing the NAM root (read/write)
		level password.
	Example:
	root@localhost.company.com# password root
Step 2
	Enter the new password.	Enters the new password.
	Example:
	New UNIX password: <password>
Step 3
	Enter the new password again.	Confirms the new password.
	Example:
	Retype new UNIX password: <password>
Step 4
	exit	Logs out of the NAM system.
	Example:
	root@localhost# exit
	Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0
OL-14942-02			43