Cord Set with 12V Cigarette Adapter

1.To permanently attach to a battery, loosen and remove each nut from the bolt at the battery terminal.

2.Connect the red POSITIVE connector ring to the POSITIVE battery terminal.

3.Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.

4.Replace and tighten the nuts to secure.

5.Connect the cable to the end of the charger output cord. Take care to keep the wires and plug away from metal and moving parts.

6.Plug the charger power cord into a grounded 120V AC electrical wall outlet.

Charge or maintain your battery without lifting the hood.

1.Connect the end of the Cord Set with 12V Cigarette Adapter to the charger.

2.Insert the 12V accessory plug into the 12V accessory outlet.

3.Route the power cord from the charger through the vehicle’s open window.

4.Plug the charger power cord into a grounded 120V AC electrical wall outlet.

5.If the vehicle’s ignition key has to be on in order for the accessory outlet to supply/receive power, turn the key on.

Battery Connection Indicator

If the charger does not detect a properly connected battery, charging will not start and the digital display will show one of two messages. If the display shows “CONNECT CLAMPS”, make sure the charger is connected to the battery and the connection points are clean and making a good connection. If the display shows “WARNING CLAMPS REVERSED”, unplug the charger from the AC outlet and reverse the connections at the battery.

Charge Completion and Maintain Mode (Float-Mode Monitoring) Charge completion is indicated by the CHARGED (green) LED turning on and the digital display showing “FULLY CHARGED AUTO MAINTAINING”. This means that the charger has stopped charging and has switched to the Maintain Mode of operation.

• 11 •