WARNING SYMBOL IDENTIFICATION
WARNING
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
WARNING
Always wear eye protection when operating or performing maintenance on this tool.
WARNING
Always wear hearing protection when operating this tool.
WARNING
Read this manual before operating tool.
AGENCY SYMBOL IDENTIFICATION
European Community Mark
Indicates compliance with relevant CE directives.
ADJUSTMENTS
CLUTCH ADJUSTMENT
Disconnect the air supply from the Tool before proceeding.
The Clutch Adjusting Hole Cover has a
1.Unscrew the Clutch Adjusting Hole Cover far enough to expose the clutch adjusting hole in the Clutch Housing.
2.Insert a 1/4” hex wrench into the Bit Holder and rotate the clutch mechanism until the area having an
opening between the faces of the Clutch Adjusting Nut Washer and Clutch Adjusting Nut is visible.
3.Using a screwdriver that has a #1 Phillips tip, insert the tip of the screwdriver into the opening and rotate the screwdriver to adjust the Clutch. Rotate the screw- driver clockwise to decrease Clutch Spring tension and torque and counterclockwise to increase the ten- sion and torque.
The most satisfactory adjustment is usually obtained by using the tool on the actual application and increasing or decreasing the delivered torque until the desired setting is reached. In any event, it is recommended that final adjustment be made by gradual progression.
P 7440 Edition 10 | 3 |