Baldor mn1854 Configure Your Application Mechanics, Mech Setup, Dist, Vmax Accel Amax, Value inch

Configuring Position Maintenance Max Velocity [ PVi ]

EDIT > SETUP > ENC > PMMAX

Value: 1.0 in/s

Range: 0.005–9,999,999.0

Limits the velocity of a position maintenance correction. Regardless of the magnitude of displacement of correction gain, the correction velocity will never exceed this maximum velocity setting.

– Axis One PM MaxVel –
←	1.0 in/s	→
Select value, press ENTER
Press ←	or → to select next axis.

Configure Your Application (Mechanics)

The MECH SETUP menu allows you to preset distance, velocity, and acceleration units convenient for your application. These units are used for all display and position reporting modes. This menu also allows you to compensate for a known amount of backlash in your mechanical system, and to set a maximum allowable speed for each axis.

Action		Display		Comments
Press EDIT key				Select a sub–menu, press F1 (PROG),
		–↑EDIT↓ –
				F2 (SETUP), or F3 (POS).
	PROG	SETUP	POS
Press F2 (SETUP) key for more				Select a sub–menu, press F1 (PROG),
		–↑SETUP↓ –
sub menu selections. Press ↓ key				F2 (RS232), or F3 (MISC).
	PROG	RS232	MISC
for more sub menu selections.
Press F3 (MECH) key				Select a sub–menu, press F1
		–↑SETUP↓ –
				(MOTOR), F2 (ENC), or F3 (MECH).
	MOTOR	ENC	MECH
Press ↓ key for more sub menu				Select a sub–menu, press F1
	←↑	MECH SETUP	↓→
selections.				(Distance), F2 (Pitch), or
	DIST	Pitch	Vel
				F3 (Velocity).
Press ↓ key for more sub menu
				Select a sub–menu, press F1 (VMAX),
	←↑	MECH SETUP	↓→
selections.				or F2 (Accel), or F3 (AMAX).
	VMAX	ACCEL	AMAX

Configuring the Distance Unit [ DUi ]

EDIT > SETUP > MECH > DIST

Value: inch

Range: inch or mm

This sets the distance units and unit label. All distance values are expressed in the units selected here.

	– Axis One Dist Units –
←↑	inch	↓→

↑or ↓ to select value, press ENTER

Press ← or → to select next axis.

MN1854 Setup 5-5