Baldor mn1854 manual Configure Home Parameters, Mode Edge Switch, Offset DIR

Configuring JOG Low Velocity [ JLr ]

EDIT > SETUP > JOG > LO–VEL

Value: 2.0 {Velocity Units}

Range: 0.0–9,999,999.0

Sets the low speed JOG velocity. Use the numeric keys to enter a value (units were selected in the SETUP > MECH > VEL menu).

Configuring JOG Low Velocity [ JHr ]

EDIT > SETUP > JOG > HI–VEL

Value: 5.0 {Velocity Units}

Range: 0.0–9,999,999.0

Sets the high speed JOG velocity. Use the numeric keys to enter a value (units were selected in the SETUP > MECH > VEL menu).

Configuring JOG Enable [ JEi ]

EDIT > SETUP > JOG > ENABLE

Value: Enabled

Range: Disabled or Enabled

Enables or disables JOG features. When disabled, an error message is displayed when the jog buttons are pressed. JOG is often disabled after installation to prevent access.

– Axis One JOG Lo–Vel –
←	2.0 in/s	→
Select value, press ENTER
Press ←	or → to select next axis.

– Axis One JOG Hi–Vel –
←	5.0 in/s	→
Select value, press ENTER
Press ←	or → to select next axis.

– Axis One JOG Enable –
←	Enabled	→
Select value, press ENTER
Press ←	or → to select next axis.

Configure HOME Parameters

The homing function combines the flexibility of a customized homing routine with the ease of use of calling a “canned program”. (Also see the GH command).

	Action		Display		Comments
Press F3 (HOME) for more sub					Select a sub–menu, press F1 (I/O), F2
		–↑SETUP↓ –
menu selections.					(JOG), or F3 (HOME).
		I/O	JOG	HOME
Press ↓	key for more sub menu				Select a sub–menu, press F1 (MODE),
		–↑HOME SETUP↓ –
selections.					F2 (EDGE), or F3 (SWITCH).
		MODE	EDGE SWITCH
Press ↓	key for more sub menu				Select a sub–menu, press F1
		–↑HOME SETUP↓ –
selections.					(OFFSET) or F2 (DIR).
		OFFSET	DIR
MN1854					Setup 5-13