Baldor mn1854 manual Configure Miscellaneous Setup Parameters

Configure Miscellaneous Setup Parameters

The miscellaneous set–up (MISC SETUP) parameters include the keypad display, and setting the deceleration rate used with a stop input (or with the ESC key while an axis is moving).

Action		Display			Comments
Press EDIT key				Select a sub–menu, press F1 (PROG),
		–↑EDIT↓ –
				F2	(SETUP), or F3 (POS).
	PROG	SETUP	POS
Press F2 (SETUP) key for more				Select a sub–menu, press F1 (PROG),
		–↑SETUP↓ –
sub menu selections.				F2	(RS232), or F3 (MISC).
	PROG	RS232	MISC
Press F1 (DISP) key for more sub				Select a sub–menu, press F1 (DISP),
		↑ MISC SETUP↓
menu selections.				F2	(Stop–Rate), or F3 (Test).
	DISP	Stop–Rate	Test

Configuring Display Format [ DF ]

EDIT > SETUP > MISC > DISP

Value: 1=POS1, 2=POS2, 3=Inputs, 4=Outputs

Range: See Table 5-3.

The “Run Time” screen of the data display can be customized. The run time screen has four 10 character segments called quadrants. Each quadrant can display one of the data types defined in Table 5-3. Select one quadrant, then assign a data type to that quadrant, press ESC to save the data type. Repeat this process for each quadrant. Note: To define the text for the “text” data type, scroll to the text data

type selection and press the “ALPHA” or a number key. A cursor is then displayed, enter up to 10 characters then press ENTER followed by the ESC key to save and exit.

<QUAD#1>		QUAD#2
QUAD#3		QUAD#4
←↑ QUAD#1 DISPLAY ↓→
↑	POS1		↓
Use the ←↑↓→	keys to select a
Quadrant (1–4), press ENTER.
Use the ↑ and ↓		keys to select a
data type.

	Table 5-3
Data Type	Description of Display Data Type
Blank	No Display
POS1 (POS2)	Axis Position (axis 1 or 2)
POS1+Unit (POS2+Unit)	Axis Position with axis units (axis 1 or 2)
VEL1 (VEL2)	Commanded Axis Velocity (axis 1 or 2)
Inputs	Discrete input status (0=Off, 1=On)
Outputs	Discrete output status (0=Off, 1=On)
OPTOS	Opto I/O status (0=off, 1=on) as configured)
SA_Status1 (SA_Status2)	SA (Tell Axis Status) serial command response (axis 1 or 2)
SS_Status	SS (Tell System Status) serial command response
Text	User defined text

MN1854 Setup 5-17