Makita LS1016L Repair DISASSEMBLY/ASSEMBLY 3-1. Blade case, Motor section, Disassembling

Repair

[3]DISASSEMBLY/ASSEMBLY [3]-1. Blade case, Motor section

DISASSEMBLING

Note: Refer to Fig. 7. The three notches on Blade case have important role for disassembly / assembly.

(1)Disconnect the linkage of Blade case with Arm and Base section by removing Strain relief and Link plate as illustrated in Figs. 8 and 9.

Fig. 8

P 6/ 37

Fig. 7

Blade case	notch A: locking Blade case to
	Base at 90 degrees
	notch B: locking Blade case
	at starting position
	notch C: locking Blade case
	at the lowest position

Aligning notch B with Stopper pin, push Knob 20 toward the notch. Blade case can be locked at starting position.

Blade case

Remove Strain reliefs from Arm complete and Blade case by unscrewing 4x12 Tapping screw (2pcs.).

Strain relief

notch B 4x12 Tapping screw

Strain relief

Knob 20 4x12 Tapping screw

Remove M4x10 Pan head screw (2pcs.) for Guard as illustrated below and then separate Guard section.

M4x10 Pan head screw (2pcs.)

Guard section

Fig. 9

Remove Link plate as illustrated below.

Link plate complete

1. Remove Stop ring E-5, Flat washer 6 and Ring 6. Link plate complete can be free from blade case.

Stop ring E-5

Flat washer 6

Ring 6

2. Remove M6x20 Hex socket head bolt, Flat washer 6 and Ring 6. Link plate complete can be free from Front arm.

M6x20 Hex socket head bolt

Flat washer 6

Ring 6