Makita LS1016L dimensions Turn Base, Base

Page 17

P 17/ 37

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-5. Turn Base, Base

DISASSEMBLING

(1)Remove the parts from Turn base and Base as illustrated in Fig. 37.

(2)Removing M8x45 Hex bolt, separate Turn base section from Base as illustrated in Fig. 38.

Fig. 37

1.Remove Upper fence, Lower fence, Guide fence and Kerf board.

Lever 45 (2pcs.)

Upper fence (2pcs.)

Lower fence (2pcs.)

Guide fence

2.Turning Grip 50 clockwise at 90 degrees, move Turn base to the direction designated with black arrow until it stops.

Kerf board

3.Remove Miter scale plate from Base by unscrewing 4x12 Tapping screw (3pcs.)

Grip 50

Miter scale plate

Fig. 38

Remove M8x45 Hex bolt with Socket wrench 13.

And remove Flat washer 8.

M8x45 Hex bolt

Flat washer 8

Turn base section

Base

Lock lever

While pressing down Lock lever, remove Turn base section from Base.

ASSEMBLING

Assemble Turn base section as illustrated in Fig. 39. And then, take the disassembling step in reverse. Refer to Fig. 37.

Fig. 39

Apply Grease to Slide plate and the center hole of Base before assembling Turn base section.

Turn base section has to be tightened with M8x45 Hex bolt so that it can smoothly turn without wobbling.

Slide plate

Base

M8x45 Hex bolt

 

Flat washer 8

Lock lever

While pressing down Lock lever, fit Turn base section to Base.

Image 17
Contents Standard equipment SpecificationOptional accessories Cutting Capacities Repair Necessary Repairing ToolsRepair Lubrications Spiral bevel gear 32 80 Helical gear Disassembling Repair DISASSEMBLY/ASSEMBLY 3-1. Blade case, Motor sectionCorrect Wrong Blade case, Motor sectionAssembling DISASSEMBLY/ASSEMBLY DISASSEMBLY/ASSEMBLY DISASSEMBLY/ASSEMBLY DISASSEMBLY/ASSEMBLY DISASSEMBLY/ASSEMBLY Safety lock mechanism 3mm Safety cover B Repair DISASSEMBLY/ASSEMBLY 3-4. Safety cover a Turn Base, Base Positive lock mechanism of Turn base Stopper pin Assembling of Square rod completeArm complete, Arm holder Front arm sectionStopper Laser Mechanism for LS1016L only Lower-slide lock mechanism AdjustmentBlade Guide fenceLaser for LS1016L only Adjustment Motor housing Circuit diagramHandle cover Handle sectionUK 110V only Handle cover Handle sectionArgentine Fig. D-1D 110-127V area except UK Inside of Case Outside of Case Wiring diagramFig. D-2A Fig. D-2D Fig. D-2E Wiring in Motor housing and Handle for UK Laser circuit section viewed from front side