P 10/ 37
Repair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Blade case, Motor section (cont.)
ASSEMBLING
(4)When assembling Motor section to Blade case, do as illustrated in Fig. 19.
Fig. 19
Handle
rib of Blade case
Lead cover
Lead cover holder
Motor housing
4x18
Tapping screw
Pressing Handle toward the rib of Blade case, assemble it to Motor housing by tightening with 4x18 Tapping screws.
Pressing Lead cover holder toward Lead cover, assemble it to Handle complete by tightening with 4x18 Tapping screw.
DISASSEMBLING
(1)Lock Blade case at starting position as illustrated in Fig. 8. And remove Link plate as illustrated in Fig. 9.
(2)Remove Motor housing and Handle section as illustrated in Figs. 13 and 14. However, no need to remove Handle cover.
(3)Tilt Blade case in the direction of Motor housing at 45 degrees to prevent Gear portion from falling off. And then, separate Gear section from Blade case as illustrated in Figs. 20 and 21.
Fig. 20
Turn Bearing retainer
While pressing Shaft lock, remove M5 Hex nut with Socket bit 8.
|
|
|
|
| M5 Hex nut |
|
| 1R361 |
|
| Spring washer 5 |
|
|
|
|
| Flat washer 5 |
|
| Bearing |
|
|
|
|
| retainer |
|
|
|
|
| M5 Hex nut |
|
|
|
Fig. 21 |
|
|
|
|
|
Remove the Screws illustrated | Insert slotted screwdrivers between | Gear section can be separated from | |||
below and Bearing retainer 51. | Blade case and Bearing box and |
| Blade case together with Bearing box. | ||
| lift up Bearing box as illustrated |
|
|
| |
M5x16 | below. |
|
|
| Spiral bevel |
|
|
|
| ||
Pan head |
|
| shaft of | gear 32 | |
screw (3pcs.) |
| Helical |
| ||
Bearing |
|
| gear 14 | Helical gear 27 | |
retainer 51 |
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| Helical gear 28 |
M5x16 Countersunk head screw (2pcs.) | Baring box |
| |||