90550129 PC1800D 4/1/09 2:38 PM Page 5
•When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords Total Length of Cord
25 ft. | 50 ft. | 75 ft. | 100 ft. | 125 ft. | 150 ft. | 175 ft. |
7.6 m | 15.2 m | 22.9 m | 30.5 m | 38.1 m | 45.7 m | 53.3 m |
Wire Size AWG |
|
|
|
|
| |
18 | 18 | 16 | 16 | 14 | 14 | 12 |
This product can accept any of the batteries and chargers listed in the chart below.
Description | Cat. # |
| Description | Cat. # | |||
Battery: | PC18BL | Battery: | PC18B | ||||
|
|
| PC18BLX | Charger: | PCMVC | ||
|
|
| PC18BLEX | ||||
Charger: |
|
| PCXMVC | ||||
PCLMVC |
|
| |||||
|
|
| |||||
|
|
| PCXMVC |
|
|
| |
FUNCTIONAL DESCRIPTION | A |
|
| 4 | |||
Figure A |
|
| 5 | 3 |
| ||
1. | Trigger Switch |
|
|
|
|
| |
2. | Forward/Reverse Button |
|
|
| 9 | 2 | |
|
|
|
|
| |||
3. | Torque Adjust Collar |
|
|
| 1 |
| |
4. | Dual Range Gearing |
|
|
|
|
| |
5. | Keyless Chuck |
|
|
|
|
| |
6. | Bit Holder |
|
|
| 6 |
| |
7. | Battery |
|
|
|
|
| 8 |
8. | Battery Release Button |
|
|
|
| 7 | |
9. | LED Work Light |
|
|
|
| ||
|
|
|
|
| |||
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.
•Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack.
: Shock hazard. Do not allow any liquid to get inside charger.
: Burn hazard. To reduce the risk of injury, charge only designated
: Under certain conditions, with the charger plugged in to the power supply, the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
5