ASSEMBLY
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.
Installing or removing the driver bit or drill bit
1. Sleeve
1
011497
Turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Turn the sleeve clockwise to tighten the chuck.
To remove the bit, turn the sleeve counterclockwise.
OPERATION
CAUTION:
•Always insert the battery cartridge all the way until it locks in place. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to you or someone around you.
Hold the tool firmly with one hand on the grip and the other hand on the bottom of the battery cartridge to control the twisting action.
Hammer drilling operation
CAUTION:
•There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole
First, turn the action mode changing ring so that the arrow
Installing the hook
1
2
3
011498
1. Groove
2. Hook
3. Screw
on the tool body points to the 
marking. The adjusting ring can be aligned in any torque levels for this operation. Be sure to use a
Position the bit at the desired location for the hole, then pull the switch trigger. Do not force the tool. Light pressure gives best results. Keep the tool in position and prevent it from slipping away from the hole.
Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed.
The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out.
Installing the bit holder (Optional accessory)
1.
1
1
2
007470
1.Bit holder
2.Bit
002449
After drilling the hole, use the
Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw.
When not using the driver bit, keep it in the bit holders. Bits 45 mm
7