•DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO
START IT. DAMAGE TO THE DRILL CAN RESULT.
•Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part of the hole.
•Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
•Make sure switch turns drill on and off.
Drilling in Wood
Holes in wood can be made with the same twist drill bits used for metal or with spade bits. These bits should be sharp and should be pulled out frequently when drilling to clear chips from the flutes.
Drilling in Metal
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
Troubleshooting
Problem | Possible Cause | Possible Solution |
• Unit will not start. | • Battery pack not installed properly. | • Check battery pack installation. |
| • Battery pack not charged. | • Check battery pack charging |
| • Attachment is not secured. | requirements. |
| • Make certain the attachment is fully | |
• Battery pack will not charge. • Battery pack not inserted into charger. | pushed into the Power Unit. | |
• Insert battery pack into charger until | ||
| • Charger not plugged in. | LED illuminates. |
| • Plug charger into a working outlet. | |
|
| Refer to “Important Charging Notes” |
| • Surrounding air temperature | for more details. |
| • Move charger and battery pack to a | |
| too hot or too cold. | surrounding air temperature of above |
|
| 40 degrees F (4,5°C) or below 105 |
• Unit shuts off abruptly. | • Battery pack has reached its | degrees F (+40,5°C). |
• Allow battery pack to cool down. | ||
| maximum thermal limit. | • Place on charger and |
| • Out of charge. ( To | |
| maximize the life of the | allow to charge. |
battery pack it is designed to shutoff abruptly when the charge is depleted.)
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.
Accessories
WARNING: The use of any accessory not recommended for use with this tool could be hazardous. Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call:
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
12