Black & Decker BDCDMT120, BDCDMT112 instruction manual Read all Instructions, Volts

Page 6

Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

 

 

 

Minimum Gauge for Cord Sets

 

Volts

 

0-25

Total Length of Cord in Feet

120V

 

26-50

51-100

101-150

240V

 

(0-7,6m)

(7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

 

0-50

51-100

101-200

201-300

 

 

 

(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)

Ampere Rating

American Wire Gauge

 

More

Not more

 

Than

Than

18

16

16

14

0

-

6

6

-

10

18

16

14

12

10 -

12

16

16

14

12

12 -

16

14

12

Not Recommended

 

 

 

 

 

 

 

Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

Do not mount charger on wall or permanently affix charger to any surface. The charger is intended to use on a flat, stable surface (i.e., table top, bench top).

Do not operate charger with damaged cord or plug — have them replaced immediately.

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to an authorized service center.

Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

Disconnect the charger from the outlet before attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

NEVER attempt to connect 2 chargers together.

The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage.

SAVE THESE INSTRUCTIONS Important Safety Instruction for Battery Packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

6

Image 6
Contents Catalog Number BDCDMT112 12V MAX BDCDMT120 20V MAX Save this manual for Future referenceVEA EL ESPA-OL EN LA Contraportada Safety Guidelines Definitions Work Area SafetySpecific Safety Rules Always Wear Certified Safety EQUIPMENT  SymbolsImportant Safety Instructions for Battery Chargers FUNCTIONAL DESCRIPTIONRead all Instructions VoltsHot/Cold pack delay 12volt max* Charging ProcedureBad battery Important charging notes20volt Max** Charging Procedure Leaving the battery in the charger Operating Power Unit Operating Drill/Screwdriver attachmentTorque Control figure Screw drivingKeyless Chuck figure H On-board bit storageTroubleshooting Rbrc SealBattery Service Information Full Two-Year Home Use WarrantyMode D’EMPLOI De catalogue BDCDMT112 12V MAX BDCDMT120 20V MAXLignes directrices en matière de sécurité définitions Page Règles de sécurité spécifiques Symboles Description FonctionnelleAvertissement Lire toutes les directives Tension Longueur totale du cordon en pieds12volt max* Procédure de charge Pile en mauvais état Fonction de suspension du bloc-piles chaud/froidRemarques importantes pour le chargement 20volt Max** Procédure de charge Bloc-piles laissé dans le chargeur20volt Max** Insertion et retrait du bloc-piles de l’outil Détente ET Commutateur Coulissant AVANT/ARRIÈREInstallation ET Retrait DES Modules Figure G Avertissement de sécurité et directives perceusesRangement intégré des mèches VissageRéglage du couple figure PerçagePerçage DU Métal DépannagePerçage DU Bois EntretienAccessoires Page Manual DE Instrucciones Catálogo N BDCDMT112 12V MAX BDCDMT120 20V MAXPautas DE SEGURIDAD/DEFINICIONES Page Normas de seguridad específicas Descripción de las funciones SímbolosAdvertencia Lea todas las instrucciones AmperajeRecomendaciones con respecto al almacenamiento MÁX* BDCDMT11212volt max* Procedimiento de carga Retraso por paquete caliente/frío Diagnóstico del cargadorBatería en mal estado Notas importantes sobre la carga20volt Max** Procedimiento de carga Para extraer el paquete de baterías Presione el botónMÁX** BDCDMT120 Dejar la batería en el cargadorPara instalar el paquete de baterías Inserte el Instalación Y Extracción DE Aditamentos Figura G Precaución Riesgo de descarga eléctrica. BajoAdvertencia Peligro de quemaduras. Las piezas Portabrocas sin llave figura H Colocación Y Extracción DE UNA Broca O UNA PuntaDestornillado Ajuste del control de torsión figuraEspacio en la herramienta para guardar brocas Detección de problemasProblema Causa posible Solución posible TaladradoMantenimiento AccesoriosEl sello Rbrc Reemplazo DE LAS Etiquetas DE Advertencia OS DE Garantia Esta Garantia no Aplica CuandoSolamente Para Propositos DE Mexico Eléctricas Tools-Electric Páginas amarillas Para Servicio y ventas
Related manuals
Manual 20 pages 10.86 Kb