WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
• Wear appropriate hearing protection during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss.
WARNING: ALWAYS use safety glasses. Everyday eye glasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
•ANSI Z87.1 eye protection (CAN/CPA Z94.3),
•ANSI S12.6 (S3.19) hearing protection,
•NOSH/OSHA respiratory protection.
Symbols
The label on your tool may include the following symbols. The symbols and their definitions are as | ||||||||
| follows: |
|
|
|
|
|
| |
V | volts | A | amperes | |||||
Hz | hertz | W | watts | |||||
min | minutes | no | alternating current | |||||
|
|
| direct current | no load speed | ||||
|
| ............. | ||||||
|
|
| ||||||
|
|
| Class I Construction |
|
|
|
| earthing terminal |
| ................. |
|
|
| .................. | |||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
| (grounded) |
|
|
| ................. | safety alert symbol |
| ................. | Class II Construction | .../min or rpm... | revolutions or | ||||
|
|
| (double insulated) |
|
|
|
| reciprocation per minute |
|
| ............. | Read instruction manual before use |
|
|
| .................. | Use proper respiratory protection |
| ................. | Use proper eye protection |
|
|
| .................. | Use proper hearing protection | |
Important Safety Instructions for Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack.
WARNING: Shock hazard. Do not allow any liquid to get inside charger.
CAUTION: Burn hazard. To reduce the risk of injury, charge only designated Black & Decker batteries. Other types of batteries may burst causing personal injury and damage. CAUTION: Under certain conditions, with the charger plugged in to the power supply, the charger can be shorted by foreign material. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
WARNING: DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated Black & Decker rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
4