HP Medical Archive Solution manual LDR X Dicom Component Configuration Settings

HPMA User Guide

DICOM

DICOM is optional The configuration settings for the LDR X DICOM component allow

on the HPMA. you to set the active state of the protocol component, select whether or not to enable the protocol on service restarts, and reset transaction counters to clear alarms.

The LDR advertises two ports to the grid, one for query and retrieve operations and one for ingest. When the DICOM component is in “Online” state, both ports are advertised. The “Online (Read-Only)” state advertises only the Q/R port and not the ingest port.

Table 66: LDR X DICOM Component Configuration Settings

Prompt	Type	Description
DICOM State	Pull-down	Sets the component to be either:
	menu	• Offline—No DICOM transactions are allowed,
			and any entity that tries to establish a DICOM
			association to the LDR receives an error message.
			Active associations are completed normally.
			DICOM component counter attributes are reset to
			zero.
		• Redirect—Transparently redirects associations to
			other LDR services. No DICOM processing is
			performed locally.
		•	Online (Read-Only)—Only the Q/R DICOM port
			is advertised to the grid.
		•	Online—Normal operation.
Auto-Start DICOM	Check box	Enables the DICOM component when the service is
		restarted. If not selected, the DICOM component
		remains Offline until explicitly enabled.
		If the check box is selected, the state on restart
		depends on the state of the Storage component. If the
		storage component is read-only on startup, the
		DICOM interface is also read-only. If the storage
		component is online, then DICOM is also online.
		Otherwise the DICOM interface remains in the
		Offline state.
Reset DICOM	Check box	When selected and applied, the counter attributes for
Counts		DICOM transactions are reset to zero. This can be
		used to clear alarms.

166

HP Medical Archive