
HPMA User Guide
| Attr. | Description | Recommended Action | |
| Code | |||
| 
 | 
 | 
 | |
| PATn | RAID controller status; indicates the | Under certain circumstances the | |
| 
 | status of the RAID monitoring and is not | monitoring module can become | |
| 
 | an indicator of the status of the RAID | shut down or disconnected. Once | |
| 
 | itself: | it is brought back up, it initializes | |
| 
 | • | 0 = Online | and rebuilds the array if necessary, | 
| 
 | • | 1 = Offline | then goes into “Online” state | 
| 
 | again. | ||
| 
 | The letter n in the Attribute Code is an | ||
| 
 | Check the RAID monitoring serial | ||
| 
 | indicator of which RAID, as some servers | ||
| 
 | cable at the back of the server to | ||
| 
 | are attached to multiple RAID units. The | ||
| 
 | make sure it is connected properly. | ||
| 
 | monitoring module is used to report sta- | ||
| 
 | If this problem persists for a | ||
| 
 | tistics on the RAID. | ||
| 
 | period of time, unplug the serial | ||
| 
 | 
 | 
 | |
| 
 | 
 | 
 | cable from the back and plug it | 
| 
 | 
 | 
 | back in. | 
| 
 | 
 | 
 | If the RAID monitoring still does | 
| 
 | 
 | 
 | not initialize, contact HP technical | 
| 
 | 
 | 
 | support. | 
| 
 | 
 | 
 | |
| PBST | FSG Backup result; whether the backup | If the backup reports “Failed”, | |
| 
 | was: | ensure there are no coincident | |
| 
 | • | 0 = Successful | HTTP alarms on LDR nodes and | 
| 
 | • | 1 = Failed | that capacity remains on some | 
| 
 | Storage Nodes. Backups are run | ||
| 
 | 
 | 
 | |
| 
 | 
 | 
 | automatically each day, and | 
| 
 | 
 | 
 | retained for two weeks. | 
| 
 | 
 | 
 | |
| PFAn | Fan State; indicates the state of the | If the fan state is anything other | |
| 
 | internal fan for the RAID: | than “OK” (0), check the fan in the | |
| 
 | • | 0 = OK | unit to ensure proper operation. If | 
| 
 | • | 1 = Speed Low | it is functioning properly but this | 
| 
 | alarm persists, contact HP techni- | ||
| 
 | • | 2 = Speed High | |
| 
 | cal support. | ||
| 
 | • | 3 = Stopped | |
| 
 | 
 | ||
| 
 | • | 4 = Failed | 
 | 
| 
 | • | 5 = Unavailable | 
 | 
| 
 | The letter n in the Attribute Code is an | 
 | |
| 
 | indicator of which RAID, as some servers | 
 | |
| 
 | are attached to multiple RAID units. | 
 | |
| 
 | 
 | 
 | 
 | 
186
HP Medical Archive