Clear paper jams
Occasionally, paper or other print media can become jammed during a print job. Some causes include the following events:
CAUTION Do NOT use any tool or sharp object to help remove paper jams.
●The input trays are loaded improperly or overfilled.
●Tray 2 or optional tray 3 is opened during a print job.
●Too many sheets accumulated in the output area, or sheets blocked the output area.
●The print media being used does not meet HP specifications. See Print on special media.
●The environment in which the print media was stored is too humid or too dry. See Print on special media.
Where to look for jams
Jams can occur in these locations:
●Inside the MFP. See Clear jams from inside the MFP.
●In input areas. See Clear jams from tray 2 or optional tray 3.
●In the output area. See Clear jams from tray output area.
Find and remove the jam by using the instructions on the following pages. If the location of the jam is not obvious, first look inside the MFP.
Loose toner might remain in the MFP after a jam. This problem should resolve itself after a few sheets have been printed.
Each section below corresponds to an area where a paper jam could occur. Use the following procedures to clear the jam. In all cases, grasp the jammed paper by both corners and pull slowly to remove the paper.
ENWW | Clear paper jams 195 |