HP Vectra VL 5/xxx manual FCC for USA only

Page 103

FCC (for USA only)

Federal Communications Commission Radio Frequency Interference Statement

Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

reorient or relocate the receiving antenna

increase the separation between the equipment and the receiver

connect the equipment into an outlet on a circuit different from that to which the receiver is connected

consult the dealer or an experienced radio/TV technician for help.

Hewlett-Packard’s FCC Compliance Tests were conducted with HP-supported peripheral devices and HP shielded cables, such as those you receive with your system. Changes or modifications not expressly approved by Hewlett-Packard could void the user’s authority to operate the equipment.

Notice for Canada

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la Class B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Safety Warning for the USA and Canada

If the power cord is not supplied with the computer, select the proper power cord according to your local national electric code.

USA: use a UL listed type SVT or SJT detachable power cord.

Canada: use a CSA certified detachable power cord.

For your safety, never remove the PC’s cover without first removing the power cord and any connection to a telecommunication network. Always replace the cover before switching on again.

Si le cordon secteur n’est pas livré avec votre ordinateur, utiliser un cordon secteur en accord avec votre code electrique national.

USA: utiliser un cordon secteur “UL listed”‚ de type SVT ou SJT.

Canada: utiliser un cordon secteur certifié CSA.

Pour votre sécurité, ne jamais retirer le capot de l’ordinateur sans avoir préalablement débranché le cordon secteur et toute connection à un réseau de télecommunication. N’oubliez pas de replacer le capot avant de rebrancher le cordon secteur.

Changing a battery

There is a danger of explosion if the battery is incorrectly installed. For your safety, never attempt to recharge, disassemble or burn the old battery. Replace the battery only with the same or equivalent type recommended by the manufacturer.The battery in this PC is a lithium battery which does not contain heavy metals, nevertheless, in order to protect the environment, do not dispose of batteries in household waste. Please return used batteries to the shop from which you bought them, to the dealer from whom you purchased the PC, or to Hewlett Packard, so that they can either be recycled or disposed of in an environmentally sound way. Returned used batteries will be accepted free of charge.

NL

Bij dit apparaat zijn batterijen geleverd. Wanneer deze leeg zijn, moet U ze niet weggooien maar inleveren als KCA.

Changement de la pile

Il y a danger d’explosion lorsque la pile n’est pas installeé correctement. Pour votre sécurité, ne jamais essayer de recharger, de démonter ou de brûler l’ancienne pile. Remplacer uniquement avec une pile du même type ou d’un type équivalent recommandé par HP. La pile de cet ordinateur est une pile au lithium qui ne contient pas de métaux lourds, néanmoins, afin de protéger l’environnement, il ne faut pas la jeter dans les ordures ménagères mais la rendre au magasin ou vous l’avez achetée, ou revendeur où vous avez achetéz l’ordinateur, ou à Hewlett Packard, pour qu’elle soit recyclée, ou stockée de manière qui ne nuit pas à l’environnement. Les piles usées seront acceptées gratuitement.

91

Image 103
Contents User’s Guide Page User’s Guide Who this Manual is For Important Safety InformationImportant Ergonomic Information Page Contents Installing Accessory Boards Installing Mass Storage DevicesRemoving and Replacing the Cover If Your PC Has a Software Problem Hewlett Packard Support and Information Services HP Setup ProgramGlossary Index Xii Setting Up and Using Your PC Try to move it without help When you receive your PC, unpack all the componentsAccessories Unpacking Your PCConnections for Models with Integrated Video Display Connecting the Mouse, Keyboard, Display and PrinterConnections for Models with MGA Millennium Video Board Electronic servicesConnecting to a Network Connecting Audio Accessories Grounded outlet Connecting the Power CablesScsi hard disk drive, this light will not work Press this button to turn the power on or off to your PCYour PC’s Hardware Control Panel Your PC’s hardware control panel is on the front of your PCStarting Your PC Starting and Stopping Your PCInitializing Your Software Starting the PC for the First TimeAfter Your PC Has Restarted Stopping Your PC Creating Master DiskettesSetting an Administrator Password Setting PasswordsAction Setting a User PasswordPassword, on Then pressAdditional Information and Help Using Power ManagementSetting Up and Using Your PC Additional Information and Help How to Install Accessories In Your PC Video Memory Accessories You Can InstallCache Memory Up to Four Accessory Boards Front-Access Device ShelfRemoving the Cover Replacing the Cover after Installing AccessoriesCheck that you have installed all your accessories Removing and Replacing the CoverMoving and Replacing the Power Supply Installing Main Memory Installing MemoryStatic electricity can damage electronic components Refer to All cables and power cordsIdentified here as C is the one closest to the processor Clip and pull the module forward and out of the socketUpgrade this to 512 KB Installing an Optional Cache Memory ModuleHandle the accessory as little as possible and with care Installing a Video Memory Upgrade Integrated Video Models To Install Video Memory ModulesAfter Installing a Video Memory Upgrade Upgrading the MGA Millennium Board Memory Switch Use Switch Block to Connecting IDE Devices Installing Mass Storage DevicesExamples of multiple IDE drive combinations Jumper SettingsConfiguring an IDE Device After Installation Configuration Connections to data cablesInstalling an IDE Hard Disk Drive in the Rear Shelf Installing an IDE Hard Disk Drive in the Bottom Shelf Page Tape drive can be installed in the bottom shelf Installing a Tape Drive in the Bottom ShelfPage Configuring Accessory Boards with Plug and Play Installing Accessory BoardsConfiguring non-Plug and Play ISA Accessory Boards Installing the Board Installing an Accessory Board refer to facing Installing a BNC Coax Adapter Remove the metal plug Remove the nut To Install a BNC Coax AdapterInstalling an OverDrive Processor Processor Cables and power cordsInstalling the Security Bracket Troubleshooting Your PC HP Summary Screen Solving ProblemsIf Your PC Does Not Start Properly Display is Blank and There Are No Error MessagesCorrectly installed If You Cannot Start Your PC from a Modem If a Post Error Message is DisplayedClear the configuration Clearing the PC’s Configuration MemoryIf Your Display is Blurred or Unreadable If Your PC Has a Hardware ProblemIf You Cannot Turn Off Your PC Display Does Not Work ProperlyIf Nothing is Displayed on the Screen Other Display ProblemsEnsure that the mouse is correctly connected If Your Keyboard Does Not WorkIf Your Mouse Does Not Work Ensure that the keyboard is correctly connectedIf Your Printer Does Not Work If the Flexible Disk Drive Does Not Work Not Work If the Hard DiskIf the Hard Disk Does Not Work CD-ROM Drive is Idle If the CD-ROM Drive Has a ProblemCable connections or jumper settings CD-ROM Drive Does Not WorkIf an Accessory Board Does Not Work If You Have Forgotten Your Password If Your PC Has a Software ProblemIf Your Application Software Does Not Work If You Have a Network ProblemIf the Date and Time are Incorrect No Sound When Running Any Applications If Your PC Has an Audio ProblemSounds MS-DOS Games Give Not enough memory ErrorsChanging the Battery Cable to the battery connector on the system board External battery as followsStrip supplied Bus Switch1 System Board SwitchesTechnical Information All measurements are in watts rms Power ConsumptionIRQs, DMAs, and I/O Addresses Used by Your PC Integrated Video Graphic Information HP Setup ProgramHewlett Packard Support and Information Services Introduction Service Means of AccessHP SupportPack Your HP Authorized ResellerRegion Phone Number Fax Number HP Support Assistant CD-ROMHP Forum on CompuServe Hewlett-Packard Information ServicesAt the CompuServe ! prompt, type GO HP HP Forum on America Online World-Wide Web URL HP BBS LibraryHP World Wide Web Site Country Number Baud RateCountry/Region Access MethodHP FAXback on Demand-HP First HP Audio Tips USA only HP Automated Support DirectoryEurope Ordering Drivers and Bios on DisketteAustralia Asia Pacific HP Support Services Country1 Language Local Number Hewlett-Packard Telephone SupportCustomer Support Center Number is +1 970Number Method of Payment Charge Type Lifeline Telephone SupportHP Network Phone-in Support Service NPS Covered Time Available From SummaryAsia Hewlett-Packard Marketing HeadquartersPage Glossary Glossary Computer is running as an unattended network server From reflecting back along the cable Index LAN IndexRegulatory Information and Warranty Regulatory Information FCC for USA only Noise Declaration for Germany HP Hardware Warranty Customer Responsibilities HP Software Product License Agreement HP Software Product Limited Warranty Your HP Vectra PC Physical Characteristics Part Number D4550-90001