HP BOOK XE3 manual Removing an Sdram Module, Removing the Sdram Cover

Removing an SDRAM Module

(User-Replaceable)

The notebook has no SDRAM on its motherboard, but has slots for two SDRAM modules. One slot contains an SDRAM module installed at the factory.

See Table 4-2 on page 4-5 for a listing of replacement SDRAM modules and part numbers.

Caution

Provide proper grounding and handle the SDRAM module only by its edges, or you could damage the module through electrostatic discharge.

Required Equipment

∙Small Phillips screwdriver.

Removal Procedure

1.Unplug the AC adapter, if present, and remove the battery.

2.On the bottom of the notebook, loosen both screws holding the SDRAM cover (the cover retains the screws), and remove the cover.

Figure 2-3. Removing the SDRAM Cover

HP OmniBook XE3 Removal and Replacement 2-5