Toshiba RAV-SM564CT-E, RAV-SM454MUT-E, RAV-SM404MUT-TR Address Setup, Address setup procedure

9. ADDRESS SETUP

9-1. Address Setup

<Address setup procedure>

When an outdoor unit and an indoor unit are connected and they are twin-triple, or when an outdoor unit is connected to each indoor unit respectively in the group operation even if multiple refrigerant lines are provided, the automatic address setup completes with power-ON of the outdoor unit. The operation of the remote control- ler is not accepted while automatic address works. (Approx. 4 to 5 minutes)

Setup of line address of outdoor unit, indoor unit address, and group address

Completion of wiring work
		NO
Do you arbitrarily set the
indoor unit address?
YES	(MANUAL)

NO

Connect one remote controller with one indoor unit (1 : 1) tentatively with communication wiring.

Is refrigerant line 1 line?		YES
NO		NO
Is group control performed?
	(To AUTO address mode)
YES
Are there multiple units		NO

of twin-triple connections?

YES

Do you change setting after

automatic setting at the first time?

YES

Turn on power of outdoor unit.

Turn on power of outdoor unit.

Turn on power of outdoor unit.

	(	After completion of address	)
Set to all indoor units one by one.		setup, change is to arbitral
		address/group manually.

Setup of automatic

(address finishes within ) 4 to 5 minutes.

END

•When the following addresses are not stored in the neutral memory (IC10) on the indoor P.C. board, a test run operation cannot be performed. (Unfixed data at shipment from factory)

	CODE No.	Data at shipment		SET DATA range
Line address	12	0099	0001	(No. 1 unit) to 0030 (No. 30 unit)
Indoor unit	13	0099	0001	(No. 1 unit) to 0064 (No. 64 unit)
address			Max. value of indoor units in the identical refrigerant line (Double twin = 4)
Group			0000	: Individual (Indoor units which are not controlled in a group)
	14	0099	0001	: Header unit (1 indoor unit in group control)
address
			0002	: Follower unit (Indoor units other than header unit in group control)

– 82 –