Toshiba RAS-10SAX, RAS-10SKX, RAS-10SK-E, RAS-10SA-E service manual How to Cancel the Auto Restart

Page 17

7-7-2. How to Cancel the Auto Restart

To cancel the Auto Restart function, proceed as follows:

Repeat the setting procedure: the unit will acknowledge the instruction and bleep three times.

• When the system is stand-by (not running)

The system will now be required to manually restart with the remote control after the main supply is turned off.

Cancellation is carried out:

OPERATION

 

MOTION

 

 

 

 

Press the TEMPORARY button

Stand-by

 

continuously more than three

 

seconds.

The system starts to operate.

The orange light will be lit.

 

 

 

 

about three seconds after

0

The unit beeps three times.

The green light will be lit.

 

 

 

3S

 

 

 

 

 

TEMPORARY

The system is operating.

 

 

 

If the system is not required to run at this time, press the TEMPORARY

 

 

 

 

button once more or use the remote control and the unit will stop.

 

 

 

 

• When the system is operating

 

 

 

 

 

 

OPERATION

 

MOTION

 

 

 

 

Press the TEMPORARY button

Operating

The orange light is lit.

continuously more than three

 

seconds.

The system stops to operate.

The orange light is turned off.

 

 

 

 

about three seconds after

0The unit beeps three times.

3S

The system stops.

TEMPORARY

If the system is not required to stop at this time, use the remote control and to restart.

During subsequent operation, the green light is light- ing.

7-7-3. In Case of Power Failure during the Timer Operation

(1)If ON-TIMER operation is reserved with setting of Auto Restart operation, it is cancelled with power failure. (The OPERATION lamp on the main unit goes on and off to inform of power failure.) In that case, try to reserve ON-TIMER operation once again.

(2)If OFF-TIMER operation is reserved without setting of Auto Restart operation, the reservation is cancelled with power failure. (The OPERATION lamp on the main unit goes on and off to inform of power failure.) In that case, try to reserve OFF- TIMER operation. When Auto Restart operation is set, OFF-TIMER reservation is also cancelled with power failure.

– 17 –

Image 17
Contents R C O Contents Primary Judgement of Trouble Sources Troubleshooting FlowchartsWhat to be Prechecked First RAS-10SK-E/10SA-E RAS-10SKX/10SAX Cooling SpecificationsCondition JIS C9612-1994 Temperature Cooling Indoor Unit Construction ViewsRAS-10SA-E RAS-10SAX Outdoor UnitMain P.C. Board Wiring DiagramParts name Type Specifications Specifications of Electrical PartsRAS-10SK-E / RAS-10SA-E RAS-10SKX / RAS-10SAX Refrigerant Cycle DiagramAUTO, COOL, DRY, FAN only MICRO-COMPUTER Block DiagramFAN only Operation Operation DescriptionsCool Operation M3/hLouver Control DRY OperationTemporary Auto Auto OperationCooling ECONO. ModeLow-Temperature Limit Control Cooling Operation Auto Restart Function How to Set the Auto RestartCase of Power Failure during the Timer Operation How to Cancel the Auto RestartSafety Cautions For general public use Installation ProcedureUK Plugs and Sockets etc Safety Regulations SI Number Attach Installation Diagram of Indoor and Outdoor UnitsOptional Parts InstallationInstallation Parts Cutting a Hole and Mounting Installation Plate Installation placeRemote control Mounting the installation plateElectrical Work When the installation plate is directly mounted on the wallHow to remove the front cabinet Wiring ConnectionHow to open the screw cap Taking out the power cordHow to install the front cabinet on the indoor unit Stripping length of connecting cableCase of rightward piping Piping and Drain Hose InstallationCase of downward piping Left-hand connection with pipingDrainage Indoor Unit InstallationStrong wind Vacuum Pumping Refrigerant Piping ConnectionFlaring Tightening connectionA5 mm hexagon wrench is required Packed Valve Handling PrecautionsHow to set the Auto Restart Auto Restart SettingOthers Gas Leak TestPower Supply Voltage Troubleshooting ChartWhat to be Prechecked First Incorrect Cable Connection between Indoor and Outdoor UnitsOperation of air-conditioner Description Misleading but Good Operations Program Controlled OperationBlock display Primary Judgement of Trouble SourcesRole of Indoor Unit Controller Selecting ordinary mode Self-diagnosis with remote controlOperating key Indication after operation Self-diagnosis by check codesCondition Code Status Preliminary checks Troubleshooting FlowchartsPower can not be Turned on No Operation at All Outdoor Unit does not Operate Power can not be Turned on after Replacing Indoor PC BoardChecking Procedure Only Compressor does not Operate Only Outdoor Fan does not Operate Only the Indoor Fan does not Operate Check procedureThere is no beep from Operating precautions How to Check the PC BoardInspection procedures Main PC board partProcedure Check Point Symptom Causes Top View Bottom View PC Board LayoutSensor How to Reduce the Operation Time of the Anti-Restart TimerIndoor Unit RAS-10SK-E, RAS-10SKX Part ReplacementPart name Procedure Remarks Microcomputer RAS-10SK-E, RAS-10SKX Outdoor Unit RAS-10SA-E, RAS-10SAX OFF Part Description Exploded Views and Parts ListIndoor Unit Capillary Tube