Toshiba RAS-10SAX, RAS-10SKX, RAS-10SK-E, RAS-10SA-E service manual Part name Procedure Remarks

No.	Part name		Procedure	Remarks
„ Horizontal grille		1) Perform the process ‚.
	Note:	2) Remove the screw fixing the louver motor, and
	The horizontal		remove the louver motor.
	grille can not be	3) Remove the shaft of the horizontal grille from the
	removed without		drain-pan.
	removing the
	louver motor.
… Heat exchanger		1) Perform the process ƒ.
		2)	Remove the pipe holder from the rear side of main
			unit by removing the screw.
		3)	Unhook the hooks fixing the left side of the heat
			exchanger and remove the screw fixing it, then
			remove the right side of the end plate from the rib
			fixing the main unit by sliding the heat exchanger
			slightly to the right side.
† Cross flow fan		1) Perform the process ƒ.
		2)	Loosen the set screw of the cross flow fan.
		3)	Remove the screw fixing the shaft bearing base.
		4)	Lift slightly up the left side of the heat exchanger,
			and pull the shaft bearing base out left downwards.
		When assembling it, fix it with the set screw on the
		position where the gap between the rear plate surface
		and the left end surface of the cross flow fan is 6 ~
		7mm.
‡ Shaft bearing		1) Perform the process † above.
		2)	Remove the shaft bearing from the shaft bearing base.
			<Caution for assembling>
		• If a part of the shaft bearing is protruded from the
			housing, assemble it after pushing its portion into
			the correct position in the housing.
ˆ Fan motor		1) Perform the process … above.
		2)	Perform the process †-2) above.
		3)	Remove the left and right motor bands.
		4)	Remove the fan motor after pulling the cross flow
			fan out sliding it left and right.
			– 49 –