Toshiba RAS-13YKV-E Dimensions related to flare processing for R410A Outer, Flare tool for R410A

c)Insertion of Flare Nut

d)Flare Processing

Make certain that a clamp bar and copper pipe have been cleaned.

By means of the clamp bar, perform the flare processing correctly.

Use either a flare tool for R410A or conven- tional flare tool.

Flare processing dimensions differ according to the type of flare tool. When using a con- ventional flare tool, be sure to secure “dimen- sion A” by using a gauge for size adjustment.

ØD

A

					Fig. 2-2-1 Flare processing dimensions
	Table 2-2-3 Dimensions related to flare processing for R410A
	Outer					A (mm)
Nominal		Thickness
						Conventional flare tool
	diameter		Flare tool for R410A
diameter		(mm)
	(mm)
			clutch type			Clutch type		Wing nut type
1/4	6,35	0,8		0 to 0,5		1,0 to 1,5		1,5 to 2,0
3/8	9,52	0,8		0 to 0,5		1,0 to 1,5		1,5 to 2,0
1/2	12,70	0,8		0 to 0,5		1,0 to 1,5		2,0 to 2,5
5/8	15,88	1,0		0 to 0,5		1,0 to 1,5		2,0 to 2,5
	Table 2-2-4 Dimensions related to flare processing for R22
	Outer					A (mm)
Nominal		Thickness
	diameter		Flare tool for R410A			Conventional flare tool
diameter		(mm)
	(mm)
			clutch type			Clutch type		Wing nut type
1/4	6,35	0,8		0 to 0,5		0,5 to 1,0		1,0 to 1,5
3/8	9,52	0,8		0 to 0,5		0,5 to 1,0		1,0 to 1,5
1/2	12,70	0,8		0 to 0,5		0,5 to 1,0		1,0 to 2,0
5/8	15,88	1,0		0 to 0,5		0,5 to 1,0		1,0 to 2,0
	Table 2-2-5 Flare and flare nut dimensions for R410A
Nominal	Outer	Thickness			Dimension (mm)			Flare nut
	diameter							width
diameter		(mm)	A		B	C	D
	(mm)							(mm)
1/4	6,35	0,8	9,1		9,2	6,5	13	17
3/8	9,52	0,8	13,2		13,5	9,7	20	22
1/2	12,70	0,8	16,6		16,0	12,9	23	26
5/8	15,88	1,0	19,7		19,0	16,0	25	29

– 8 –