HP 8000 tower manual A.14 Hard Drive Error Messages

Page 107

A.14 Hard Drive Error Messages (19xx-xx)

Error Messages and Codes

A.14 Hard Drive Error Messages (19xx-xx)

Table A-13

Hard Drive Error Messages

Message	Probable Cause	Message	Probable Cause

19xx-01	Drive not installed	19xx-21	Got servo pulses second time but not first

19xx-02	Cartridge not installed	19xx-22	Never got to EOT after servo check

19xx-03	Tape motion error	19xx-23	Change line unset

19xx-04	Drive busy error	19xx-24	Write-protect error

19xx-05	Track seek error	19xx-25	Unable to erase cartridge

19xx-06	Tape write-protect error	19xx-26	Cannot identify drive

19xx-07	Tape already Servo Written	19xx-27	Drive not compatible with controller

19xx-08	Unable to Servo Write	19xx-28	Format gap error

19xx-09	Unable to format	19xx-30	Exception bit not set

19xx-10	Format mode error	19xx-31	Unexpected drive status

19xx-11	Drive recalibration error	19xx-32	Device fault

19xx-12	Tape not Servo Written	19xx-33	Illegal command

19xx-13	Tape not formatted	19xx-34	No data detected

19xx-14	Drive time-out error	19xx-35	Power-on reset occurred

19xx-15	Sensor error flag	19xx-36	Failed to set FLEX format mode

19xx-16	Block locate (block ID) error	19xx-37	Failed to reset FLEX format mode

19xx-17	Soft error limit exceeded	19xx-38	Data mismatch on directory track

19xx-18	Hard error limit exceeded	19xx-39	Data mismatch on track 0

19xx-19	Write (probably ID ) error	19xx-40	Failed self-test

19xx-20	NEC fatal error	19xx-91	Power lost during test

1900-xx = Tape ID test failed		1904-xx = Tape BOT/EOT test failed
1901-xx = Tape servo write failed		1905-xx = Tape read test failed
1902-xx = Tape format failed		1906-xx = Tape R/W compare test failed
1903-xx = Tape drive sensor test failed		1907-xx = Tape write-protect failed

Technical Reference Guide

www.hp.com

A-15

Image 107

Contents December Technical Reference GuideHP Compaq 8000 Elite Series Business Desktop Computers Document Part NumberFirst Edition December Document Part Number Technical Reference GuideHP Compaq 8000 Elite Series Business Desktop Computers 2 System Overview Contents1 Introduction 5 Input/Output Interfaces 3 Processor/Memory Subsystem4 System Support 6 Integrated Graphics Subsystem 7 Power and Signal DistributionA Error Messages and Codes Index 8 SYSTEM BIOS1.1.1 Online Viewing Introduction1.1 About this Guide 1.2 Additional Information Sources1.4.2 Values 1.3 Serial Number1.4 Notational Conventions 1.4.1 Special NoticesAbbreviation 1.5 Common Acronyms and AbbreviationsAcronyms and Abbreviations Acronym orTable 1-1 Continued Abbreviation Table 1-1 ContinuedAcronyms and Abbreviations Acronym orAbbreviation Table 1-1 ContinuedAcronyms and Abbreviations Acronym orAbbreviation Table 1-1 ContinuedAcronyms and Abbreviations Acronym orAbbreviation Table 1-1 ContinuedAcronyms and Abbreviations Acronym orAbbreviation 1-10 2.1 Introduction System Overview2.2 Features USDT Feature Differences by Form FactorArchitectural Differences by Form Factor 2.3 System ArchitectureTechnical Reference Guide Chipset Components and Functionality 2.3.1 Intel Processor Support2.3.2 Chipset Support Component Functions 2.3.3 Support Components2.3.4 System Memory 2.3.8 Network Interface Controller 2.3.5 Mass Storage2.3.6 Serial Interface 2.3.7 Universal Serial Bus InterfaceIntegrated Graphics Subsystem Statistics 2.3.9 Graphics Subsystem2.3.10 Audio Subsystem Environmental Specifications Factory Configuration 2.4 Specifications2.3.11 HP ProtectTools Embedded Security Physical Specifications Power Supply Electrical Specifications2-12 3.1 Introduction Processor/Memory Subsystem3.2.1 Intel Processor Overview 3.2 Intel ProcessorsSupported Processors partial listing 3.2.2 Processor Changing/Upgrading3.3 Memory Subsystem Memory Socket Loading 3.3.1 Memory Upgrading3.3.2 Memory Mapping and Pre-allocation Base Memory Figure 3-2. System Memory Map for maximum of 8 gigabytesExpansion Area 4.2.1 PCI 2.3 Bus Operation System Support4.1 Introduction 4.2 PCI Bus OverviewPCI Bus PCI Component Configuration AccessWired to System SupportPCI Bus Mastering Devices 4.2.2 PCI Express Bus OperationSoftware/Driver Layer Transaction Protocol LayerLink Layer 4.2.5 PCI Power Management Support4.2.3 Option ROM Mapping 4.2.4 PCI InterruptsFigure 4-2. 32-bit, 5.0-volt PCI 2.3 Bus Connector 4.2.6 PCI ConnectorsPCI 2.3 Connector PCI 2.3 Bus Connector PinoutFigure 4-3. PCIe Bus Connectors PCIe ConnectorsPCIe Bus Connector Pinout APIC Mode 4.3 System Resources4.3.1 Interrupts 8259 ModePCI Interrupt Distribution 4.3.2 Direct Memory Access4.4.1 Clearing CMOS 4.4 Real-Time Clock and Configuration MemoryConfiguration Memory CMOS Map 4.5 System Management4.4.2 Standard CMOS Locations 4.5.1 Security FunctionsI/O Interface Security Power-On / Setup PasswordSetup Password Cable Lock ProvisionACPI Wake-Up Events 4.5.2 Power ManagementSmart Cover Lock Optional System Operational Status LED Indications 4.5.3 System Status4.5.4 Thermal Sensing and Cooling 4.6.1 System I/O Map 4.6 Register Map and Miscellaneous FunctionsFunction System I/O MapI/O Port SIO Controller Functions 4.6.2 GPIO FunctionsICH10 Functions 5.1 Introduction Input/Output Interfaces5.2.1 SATA interface 5.2 SATA/eSATA Interfaces5.2.2 eSATA interface DB-9 Serial Connector Pinout 5.3 Serial Interface5.4.3 Extended Capabilities Port Mode 5.4 Parallel Interface Support5.4.1 Standard Parallel Port Mode 5.4.2 Enhanced Parallel Port Modee w q - 9 8 7 6 5 4 3 2 1 g f d s a p o i u y t r 5.4.4 Parallel Interface ConnectorDB-25 Parallel Connector Pinout 5.5.1 Keyboard Interface Operation 5.5 Keyboard/Pointing Device InterfaceKeyboard/Pointing Device Connector Pinout 5.5.3 Keyboard/Pointing Device Interface Connector5.5.2 Pointing Device Interface Operation 5.6 Universal Serial Bus Interface 5.6.1 USB ConnectorUSB Color Code 5.6.2 USB Cable DataUSB Connector Pinout USB Cable Length DataFigure 5-8. Audio Subsystem Functional Block Diagram 5.7 Audio Subsystem5.7.3 Audio Multistreaming 5.7.1 HD Audio Controller5.7.2 HD Audio Link Bus HD Audio Subsystem Specifications 5.7.4 Audio SpecificationsThe specifications for the HD Audio subsystem are listed in Table 5.8 Network Interface Controller 5.8.2 Alert Standard Format Support 5.8.3 Power Management Support5.8.1 Wake-On-LAN Support Table 5-11. NIC Specifications 5.8.4 NIC Connector5.8.5 NIC Specifications 6.1 Introduction Integrated Graphics Subsystem6.2 Functional Description Maximum Memory Allocation SDRAM InstalledGMA 4500 Memory Allocation 6.3 Display Modes 6.4 Upgrading 6.5.1 Analog Monitor Connector 6.5 Monitor ConnectorsFigure 6-3. DisplayPort Connector, as viewed from rear of chassis 6.5.2 DisplayPort ConnectorTechnical Reference Guide 7.1 Introduction Power and Signal Distribution7.2 USDT Power Distribution Figure 7-2. SFF/CMT Power Distribution and Cabling, Block Diagram 7.3 SFF/CMT Power DistributionTable 7-1 lists the specifications of the external supply USDT 135-Watt Power Supply Unit SpecificationsCMT 320-Watt Power Supply Unit Specifications SFF 240-Watt Power Supply Unit Specifications7.4.1 Power Button 7.4 Power ControlPre-video memory error. Incompatible or incorrectly seated Power LED IndicationsPower LED Power failure power supply is overloaded. Check storageWake-On-LAN 7.5 Power Management7.4.2 Wake Up Events Power Management EventState System Power StatesPower PowerComponent function 7.6 Signal DistributionSystem Board Connector, Indicator, and Switch Designations DesignatorFigure 7-3. System Board Header Pinouts Figure 7-5 shows pinouts of headers used on the sytem boardsTable 7-7. Continued 7-10 8.1 Introduction System BIOS8.2.2 Changeable Splash Screen 8.2 ROM Flashing8.2.1 Upgrading 8.3.3 Memory Detection and Configuration 8.3 Boot Functions8.3.1 Boot Device Order 8.3.2 Network Boot F12 Support8.3.4 Boot Error Codes 8.4 Client Management Functions System ID Numbers 8.4.1 System ID and ROM Type8.4.2 Temperature Status SMBIOS Functions 8.5 SMBIOS8.7 Management Engine Functions 8.6 USB Legacy SupportA.1 Introduction Error Messages and CodesA.2 Beep/Power LED Codes Error Messages and Codes A.3 Power-On Self Test POST Messages1796-SATA Cabling Error Power-On Self Test POST MessagesError Message 1794--Inaccessible device attached to SATA1801-Microcode Patch Error Error Messages and Codes A.4 System Error MessagesTable A-4 A.5 Memory Error MessagesMemory Error Messages Message A.6 Keyboard Error MessagesMemory Error Messages Table A-4. ContinuedInt. test, LpBk. test., and cntrl. register failed A.7 Printer Error MessagesA.8 Video Graphics Error Messages Int. test, LpBk. test., and data register failedA.9 Diskette Drive Error Messages Table A-9 Serial Interface Error Messages A.10 Serial Interface Error MessagesTable A-10 Modem Communications Error Messages A.11 Modem Communications Error MessagesA.12 System Status Error Messages Cntlr. failed to deallocate bad sectors A.13 Hard Drive Error Messagesxx = 00, Hard drive ID test xx = 01, Hard drive format test A.14 Hard Drive Error Messages Lightpen graphics test failed, no resp A.15 Video Graphics Error MessagesA.16 Audio Error Messages EGA Mono. graphics mode test failedA.18 Network Interface Error Messages A.17 DVD/CD-ROM Error MessagesProbable Cause A.19 SCSI Interface Error Messages 65xx-xx, 66xx-xxMessage A.20 Pointing Device Interface Error Messages 8601-xx A-20 Numerics Index

Related manuals

Manual 18 pages 10.45 Kb

Manual 29 pages 22.5 Kb

Manual 1 pages 60.13 Kb