HP 8000 tower manual GMA 4500 Memory Allocation, SDRAM Installed, Maximum Memory Allocation

Integrated Graphics Subsystem

The GMA 4500 uses a portion of system memory for instructions, textures, and frame (display) buffering. Using a process called Dynamic Video Memory Technology (DVMT), the controller dynamically allocates display and texture memory amounts according to the needs of the application running on the system.

The total memory allocation is determined by the amount of system memory installed in a system. The video BIOS pre-allocates 8 megabytes of memory during POST. System memory that is pre-allocated is not seen by the operating system, which will report the total amount of memory installed less the amount of pre-allocated memory.

The GMA 4500 will use, in standard VGA/SVGA modes, pre-allocated memory as a true dedicated frame buffer. If the system boots with the OS loading the GMA Extreme Graphics drivers, the pre-allocated memory will then be re-claimed by the drivers and may or may not be used by the GMA in the “extended” graphic modes. However, it is important to note that pre-allocated memory is available only to the GMA, not to the OS.

The Q45's DVMT function is an enhancement over the Unified Memory Architecture (UMA) of earlier systems. The DVMT of the Q45 selects, during the boot process, the maximum graphics memory allocation possible according on the amount of system memory installed:

Table 6-1.

GMA 4500 Memory Allocation

SDRAM Installed		Maximum Memory Allocation
1	GB	256 or 512 MB
>	1 GB	384 MB

The actual amount of system memory used by the GMA in the “extended” or “extreme” modes will increase and decrease dynamically according to the needs of the application. The amount of memory used solely for graphics (video) may be reported in a message on the screen, depending on the operating system and/or applications running on the machine.

For viewing the maximum amount of available frame buffer memory MS Windows go to the Control Panel and select the Display icon, then > Settings > Advanced > Adapter.

The Microsoft Direct Diagnostic tool included in most versions of Windows may be used to check the amount of video memory being used. The Display tab of the utility the “Approx. Total Memory” label will indicate the amount of video memory. The value will vary according to OS.

✎Some applications, particularly games that require advanced 3D hardware acceleration, may not install or run correctly on systems using the GMA.

Technical Reference Guide www.hp.com 6-3