HP Cooktop 10GBE manual Accessing the pass-thru module CLI remotely

Page 10

4.Close the handle (2).

Complete installation is indicated by a green Health LED. If the Health LED is amber or power is not applied to the module, see the HP BladeSystem Enclosure Setup and Installation Guide for troubleshooting information.

Accessing the pass-thru module CLI

You can access the pass-thru module CLI remotely using the Onboard Administrator enclosure or locally using the mini-USB to DB-9 RS232 Management serial port.

Accessing the pass-thru module CLI remotely

1.Access the Onboard Administrator command line using telnet, SSH, or a serial connection. For more information on how to access the Onboard Administrator CLI, see the HP BladeSystem Onboard Administrator User Guide.

2.Use the connect interconnect <bay> command to access the module. For example, if the module is located in bay 2, enter the connect interconnect 2 command.

To properly connect to the pass-thru module, you must disable flow control in the Onboard Administrator connect console.

To disable flow control after you have connected to the module:

1.Press Enter.

2.Press Ctrl + _ (Ctrl + Shift + underscore) to access the Connect Utility menu.

3.Enter C to change the port settings.

4.Enter R to change settings for the remote port.

5.Enter N to disable flow control.

After you have exited the menu, the pass-thru module CLI appears.

NOTE: If the pass-thru module CLI does not appear, press Enter.

Installing the pass-thru module 10

Image 10
Contents 10GbE Pass-Thru Module User Guide Part Number December 2010 Second EditionIntended audience Contents Electrostatic discharge Introduction FeaturesPass-thru module architecture Port mapping Dual pass-thru modules XModemRedundant paths to server bays 10GbE Pass-Thru Module front panel ResetsComponent identification DescriptionDescription Installing the module Installing the pass-thru moduleManually configuring the pass-thru module Module securityAccessing the pass-thru module CLI Accessing the pass-thru module CLI remotelyCommand Result Accessing the pass-thru module CLI locallyProduction mode CLI CLI menuInstalling SFP+ transceivers Replacing a pass-thru module Replacing an existing moduleUpdating the 10GbE pass-thru firmware Methods for updating the 10GbE Pass-Thru Module firmwareEnter N. The following message appears Enter C. The following message appearsEnter R. The following message appears Enter y. The following message appearsEnter x. The following message appears Configuration Script Files Usb//d1/test.cfg Updating the firmware image using the serial port Performing a serial firmware image downloadBaud rate 9600 Data bits Parity None Stop bits Flow control For more information Additional referencesHealth LED on the pass-thru module is not on TroubleshootingCause Action Try another mini-USB to DB-9 RS232 cable SFP+ transceiver port is disabled Pass-thru module configuration is corruptDownload fails after starting to download the firmware file Category Specification Technical specificationsGeneral specifications Port namesFrom Wire Physical and environmental specificationsMini-USB to DB-9 serial adapter pin assignment Shell Braid Technical specifications Regulatory compliance notices Regulatory compliance notices Regulatory compliance notices Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Power-On Self Test Media Access ControlNetwork access server Local-area networkIndex Index