HP Cooktop 10GBE manual Baud rate 9600 Data bits Parity None Stop bits Flow control

Page 19

NOTE: The pass-thru module boot code firmware image is usually named 10GPTHRU- w.x.y.z_FW.bin, where w.x.y.z is the firmware version number.

1.Using the null modem mini-USB to DB-9 cable, connect the console port of the pass-thru module to the serial port of a computer that supports XModem/1K XModem.

2.Start HyperTerminal (part of Microsoft® Windows® operating system) or equivalent terminal emulation application (depending on the operating system), and set the parameters for terminal emulation console:

Parameter

Value

 

 

Baud rate

9600

 

 

Data bits

8

 

 

Parity

None

 

 

Stop bits

1

 

 

Flow control

None

 

 

3.Power on or reboot the pass-thru module.

4.Hold down the Shift key and press the B key repeatedly during boot up, until the following message appears: "Ready to begin XMODEM file transfer. Press Enter to continue."

5.Repeatedly press the Enter key on the computer that is connected to the console port of the pass-thru module. When the console port is successfully communicating with the computer, indicating readiness for image transfer, continuous Cs appear.

6.Be sure that the new pass-thru module boot code firmware file is available on the computer. This file can be downloaded from the HP website (http://www.hp.com/go/bladesystem/documentation).

7.Select <Transfer-Send File> from the menu, and choose the following options in the Send File window:

Filename: C:\#*!<unassigned_variable!*#

Protocol: 1K XMODEM

The Send File window displays the progress of the file transfer. The file transfer might take up to 7 minutes.

NOTE: Although slower, XModem also works if 1K XModem is not used.

After completing the transfer, the new image automatically boots.

Updating the 10GbE pass-thru firmware 19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Part Number December 2010 Second Edition 10GbE Pass-Thru Module User GuideIntended audience Contents Electrostatic discharge Introduction FeaturesPass-thru module architecture Port mapping Dual pass-thru modules XModemRedundant paths to server bays Description ResetsComponent identification 10GbE Pass-Thru Module front panelDescription Module security Installing the pass-thru moduleManually configuring the pass-thru module Installing the moduleAccessing the pass-thru module CLI remotely Accessing the pass-thru module CLICLI menu Accessing the pass-thru module CLI locallyProduction mode CLI Command ResultInstalling SFP+ transceivers Replacing an existing module Replacing a pass-thru moduleMethods for updating the 10GbE Pass-Thru Module firmware Updating the 10GbE pass-thru firmwareEnter y. The following message appears Enter C. The following message appearsEnter R. The following message appears Enter N. The following message appearsEnter x. The following message appears Configuration Script Files Usb//d1/test.cfg Performing a serial firmware image download Updating the firmware image using the serial portBaud rate 9600 Data bits Parity None Stop bits Flow control Additional references For more informationHealth LED on the pass-thru module is not on TroubleshootingCause Action Try another mini-USB to DB-9 RS232 cable SFP+ transceiver port is disabled Pass-thru module configuration is corruptDownload fails after starting to download the firmware file Port names Technical specificationsGeneral specifications Category SpecificationFrom Wire Physical and environmental specificationsMini-USB to DB-9 serial adapter pin assignment Shell Braid Technical specifications Regulatory compliance notices Regulatory compliance notices Regulatory compliance notices Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Local-area network Media Access ControlNetwork access server Power-On Self TestIndex Index
Top Page Image Contents