HP Cooktop 10GBE manual Enter x. The following message appears

Page 16

12.Press the Enter key. The module console begins to print C characters until the Xmodem transfer begins.

13.Press Ctrl + Shift + _. The following message appears:

Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode X)modem send >

14.Enter x. The following message appears:

Xmodem Send: Send a file to the interconnect module using the xmodem transfer protocol. The file can be downloaded to the OA from an HTTP(S), FTP, or TFTP server. After the file has been downloaded, the OA will transfer it to the switch. Please enter the URL below.

15.Enter the transfer URL (tftp://tftpServerIPAddress/10GPTHRU-1.0.7.0_FW.bin). The following message appears:

Downloading file ... successful (transferred 210216 bytes) Continue with transfer (yes/no)?

16.Enter y. The following message appears:

Starting transfer. Press '<Ctrl>_' (Control + Shift + Underscore) to cancel.

Note: The transfer will terminate after 30 seconds of inactivity.

……….

The pass-thru module displays multiple lines of . characters until the entire firmware transfer is complete. The following message appears:

Transfer complete.

Welcome to the HP 10GbE Pass-Thru Module Running image 1.0.7.0

Initializing ports................................

[10Gb Pass-Thru Menu] system - System Menu

port - Port Menu

global - Global Commands Menu

10Gb Pass-Thru# Port 1 is ENABLED Port 2 is ENABLED

Port 3 is ENABLED Port 5 is ENABLED Port 6 is ENABLED Port 7 is ENABLED Port 8 is ENABLED Port 9 is ENABLED Port 10 is ENABLED Port 11 is ENABLED Port 12 is ENABLED

Updating the 10GbE pass-thru firmware 16

Image 16

Contents 10GbE Pass-Thru Module User Guide Part Number December 2010 Second EditionIntended audience Contents Electrostatic discharge Introduction FeaturesPass-thru module architecture Port mapping Dual pass-thru modules XModemRedundant paths to server bays Resets Component identification10GbE Pass-Thru Module front panel DescriptionDescription Installing the pass-thru module Manually configuring the pass-thru moduleInstalling the module Module securityAccessing the pass-thru module CLI Accessing the pass-thru module CLI remotelyAccessing the pass-thru module CLI locally Production mode CLICommand Result CLI menuInstalling SFP+ transceivers Replacing a pass-thru module Replacing an existing moduleUpdating the 10GbE pass-thru firmware Methods for updating the 10GbE Pass-Thru Module firmwareEnter C. The following message appears Enter R. The following message appearsEnter N. The following message appears Enter y. The following message appearsEnter x. The following message appears Configuration Script Files Usb//d1/test.cfg Updating the firmware image using the serial port Performing a serial firmware image downloadBaud rate 9600 Data bits Parity None Stop bits Flow control For more information Additional referencesHealth LED on the pass-thru module is not on TroubleshootingCause Action Try another mini-USB to DB-9 RS232 cable SFP+ transceiver port is disabled Pass-thru module configuration is corruptDownload fails after starting to download the firmware file Technical specifications General specificationsCategory Specification Port namesFrom Wire Physical and environmental specificationsMini-USB to DB-9 serial adapter pin assignment Shell Braid Technical specifications Regulatory compliance notices Regulatory compliance notices Regulatory compliance notices Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Media Access Control Network access serverPower-On Self Test Local-area networkIndex Index