HP Cooktop 10GBE manual Replacing a pass-thru module, Replacing an existing module

Page 13

Replacing a pass-thru module

Replacing an existing module

CAUTION: Removing the pass-thru module from a powered enclosure results in the loss of network communications between the server blade network ports and the network infrastructure.

For continued blade-server network communication and services availability before removing the module, redirect critical high-availability services or applications to use the redundant network ports.

CAUTION: Do not connect the pass-thru module until after configuration.

1.Remove and label the cables.

2.Remove the module.

3.Slide the new module fully into the interconnect bay. For more installation information, see "Installing the module (on page 9)."

4.Close the ejector lever and wait for the module to boot completely.

Replacing a pass-thru module 13

Image 13

Contents Part Number December 2010 Second Edition 10GbE Pass-Thru Module User GuideIntended audience Contents Electrostatic discharge Introduction FeaturesPass-thru module architecture Port mapping Dual pass-thru modules XModemRedundant paths to server bays Component identification Resets10GbE Pass-Thru Module front panel DescriptionDescription Manually configuring the pass-thru module Installing the pass-thru moduleInstalling the module Module securityAccessing the pass-thru module CLI remotely Accessing the pass-thru module CLIProduction mode CLI Accessing the pass-thru module CLI locallyCommand Result CLI menuInstalling SFP+ transceivers Replacing an existing module Replacing a pass-thru moduleMethods for updating the 10GbE Pass-Thru Module firmware Updating the 10GbE pass-thru firmwareEnter R. The following message appears Enter C. The following message appearsEnter N. The following message appears Enter y. The following message appearsEnter x. The following message appears Configuration Script Files Usb//d1/test.cfg Performing a serial firmware image download Updating the firmware image using the serial portBaud rate 9600 Data bits Parity None Stop bits Flow control Additional references For more informationHealth LED on the pass-thru module is not on TroubleshootingCause Action Try another mini-USB to DB-9 RS232 cable SFP+ transceiver port is disabled Pass-thru module configuration is corruptDownload fails after starting to download the firmware file General specifications Technical specificationsCategory Specification Port namesFrom Wire Physical and environmental specificationsMini-USB to DB-9 serial adapter pin assignment Shell Braid Technical specifications Regulatory compliance notices Regulatory compliance notices Regulatory compliance notices Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Network access server Media Access ControlPower-On Self Test Local-area networkIndex Index